皮套圈座多轴钻孔专机设计论文【毕业论文+CAD图纸全套】.doc

摘 要 随着自动化，现代工厂中 关键词： Abstract With increasing automation applications, combined machine tool more and more appear in modern factories, the combination of more occasions based on general parts, match with workpiece specific shape and process design of special components and fixtures, composed of semi-automatic or automatic special machine. It usually adopts the multiaxial, knife, processes, and multi-faceted or multistage and processing, production efficiency than general machine high several times or more. Due to the common parts have standard series, can according to the combined flexible configuration, can shorten the cycle of design and manufacture. Therefore, the combination machine has the advantages of low cost and high efficiency, in large, mass production is widely used, and the automatic production line can be used to composition. The design for the leather seat drilling machine, the processing at the same time to complete the 3 hole.This design mainly in the following aspects: 1. According to the formulation of programmes, providing the parts drawing through relevant material analysis, the feasibility plan and plan formulated processing procedures; 2. three graph one card : process graph, processing schemes, size contact drawing and productivity calculation according to requirements of calculation, card design drawings; 3. Spindle box structure design, including power system and transmission system, the design of the formulation of shaft, the gear design, bearing the formulation of choice, lubricating system; 4. Component drawing, including shaft, gear; 5. Written instructions. Key words: Unit built machine tool; Spindle box; Three diagram a card 目 录 III Abstract IV 目 录 V 1 绪论 1 1.1 课题的来源及意义 1 1.2 组合机床及特点 1 1.3 国内外该研究技术现状 1 2 组合机床总体方案设计 2 2.1 组合机床的设计步骤 2 2.2 编制工艺规程的原始资料 2 2.2.1 被加工零件图一张 2 2.2.2 零件机械加工工艺路线的拟定 4 2.2.3 工序的加工余量及切削刀具的选择 5 2.2.4 切削刀具的选择 5 2.3 组合机床切削用量选择及计算 5