2013深圳移动入围考试复习题.docx

瀚信试题(机密)2013深圳移动入围考试复习题一、单选题 1二、多选题64三、判断题 113四、填空题 133五、问答题 142一、单选题1、LAPDm信令用于：A.MSC与 BSC之间B.BTS与 BSC之间C.BSC与 TCSM2E之间D.BTS与 MS之间参考答案：D2、以下哪个现象不存在模拟网，而只存在于数字无线网中?A.瑞利衰落B.拥塞C.快衰落D.码间干扰参考答案：D3、如果 LAPD信令为 64KBit/s,则一根在 ABIS口上的 PCM线最多可支持多少个 TRX？A.12B.10C.8D.13E.都不对参考答案：B4、为避免因过多跨越 LAC的小区重选而造成的 SDCCH的阻塞,我们将与该小区有切换关系且与之 LAC不同的相邻小区的参数提高?A.T3212B.Cell_Reselect_HysteresisC.Cell_Reselect_offset瀚信试题(机密)D.Rxlev_Access_Min参考答案：B5、When perform inter BSC handover, the BSC send “Handover Required” message to MSC,genHandoverRequestMessage=3 means?A.Handover required message could be repeated for 3 timesB.There are 3 handover required messages were sentC.3 preferred cells are included in the Handover required messageD.A handover required message contains 3 handover requests参考答案：C6、One cell has 2 TRXs (14 timeslots used for TCH). How many Erlang can this cell carry if the QoS(blocking rate) is 2%?A.2.7 ErlangB.8.2 ErlangC.16.0 ErlangD.14.0 Erlang参考答案：B7、The number of MS that can be paged with one paging message depends on?A.paging groups per multiframeB.MFRC.AGD.TMSI or IMSI paging参考答案：D8、Which of the following is not power control type?A.BS power increase due to UL signal qualityB.BS power decrease due to UL signal qualityC.BS power increase due to UL interferenceD.BS power increase due to UL signal levelE.BS power decrease due to UL signal level参考答案：C9、什么是 system balance?A.每个小区可以承载相同数目的用户B.网络可以支持不同 class的移动台C.所有的 BTS的发射功率都是同样大小的D.MS与 BTS都在满足其接收灵敏度的条件下工作参考答案：D10、位置更新过程是由下列谁发起的A.移动交换中心（MSC）B.拜访寄存器（VLR）瀚信试题(机密)C.移动台（MS）D.基站收发信台（BTS）参考答案：C11、BSC从哪儿提取时钟同步信号：A.HLRB.MSCC.BTSD.TRU参考答案：B12、无线信号的频率越高，在空气中传播的损耗越______，无线信号在水面上传播比在空气中传播的损耗______。A.大、大B.小、小C.大、小D.小、大参考答案：C13、2W＝______dBmA.10B.20C.30D.33参考答案：D14、GSM系统使用的多址方式为______。A.FDMAB.TDMAC.CDMAD.FDMA+TDMA参考答案：D15、GSM系统中时间提前量（TA）的一个单位对应空间传播的距离接近米。A.450B.500C.550D.600参考答案：C16、The BTS needs not to calculate the Timing Advance value inA.Dedicated ModeB.Idle ModeC.Location Update phase瀚信试题(机密)D.Network Camping phaseE.SMS transmission phase参考答案