冷却塔计算书.docx

Evonik Marco Polo一体化异氟尔酮及多用户基地冷却塔项目Support scaffold calculation脚手架计算书Composer编制：Inspection审核：Approval批准：Zhongshi Chemical Engineering Construction Co.,Ltd. Evonik Degussa Special Chemical (Shanghai)中石化工建设有限公司嬴创德固赛（上海）项目Year 2012, Month NOV.2012年11月 Support scaffold calculation支撑脚手架计算书Steel pipe scaffold calculation refer to the Construction Fastener Type Steel Pipe Scaffold Safety Technical Specifications (JGJ130-2011), the Code for Design of Building Foundation (GB 50007-2002), the Building Structure Load Standard (GB 50009-2001), the Steel Structure Design Standard (GB 50017-2003), and other norms.钢管脚手架的计算参照《建筑施工扣件式钢管脚手架安全技术规范》(JGJ130-2011)、《建筑地基基础设计规范》(GB 50007-2002)、《建筑结构荷载规范》(GB 50009-2001)、《钢结构设计规范》(GB 50017-2003)等规范。1、Structure requirements构造要求（1）Poling: vertical and horizontal spacing 1.2×1.2 m, allowing the build-up deviation ± 5 cm, poling vertical degree allow build-up deviation ± 10 cm. The bottom shall set sweeping bar, from plate up to 20 cm, adopt butt extension. Extension length of sweeping bar in the end and poling junction over fastener less than or equal to 20cm.立杆：纵横向立杆间距1.2×1.2m，允许搭设偏差±5cm,立杆垂直度允许搭设偏差±10 cm。下部设扫地杆，扫地杆从垫板往上20 cm处设置，扫地杆采用对接接长。扫地杆在端头与立杆交接处伸出扣件长度不大于20cm。（2）Rail: set a full bidirectional horizontal bar between poling, vertical and horizontal tie beam step distance of 1.5 m, ensure it has enough design stiffness in two direction, rail with butt method extension, the elevation difference of a piece of rail on both ends not more than 2 cm, the planeness of longitudinal bar not less than ± 1 cm. To prevent level rail produce eccentric bend distance influence to poling rod, in the build-up formwork support, will rail symmetry and arrangement. Refer map below.横杆：立杆之间满设双向水平杆，纵横向水平拉杆步距1.2m，确保其在两个方向都具有足够的设计刚度，横杆用对接方法接长，一根横杆两端的高差，不能超过2 cm，纵向水平杆全长平整度不小于±1cm。为防止水平横杆对立杆产生偏心弯距的影响，在搭设模板支架时，将横杆对称相间布置。（3）Bracing: around the support set shear brace full, and should set up continuously.剪刀撑：沿支架四周外满设剪力撑，且应连续设置。（4）Joint node requirements: longitudinal bar