产品规范.docVIP

SPECIFICATION SPEC. NO.： SP-BATHVAB REV： A DATE： 2010.09.20 PRODUCT NAME： BATTERY CONNECTOR SERIES PRODUCT NO： BATHV-00XXX-TPXX 優群科技股份有限公司 ARGOSY RESEARCH INC. 221台北縣汐止市新台五路1段81號8之6 8F-6, NO. 81, Sec. 1, Hsin Tai Wu Rd., His-Chih, Taipei Hsien 221, Taiwan TEL：+886-2-2698-1585 FAX：+886-2-2698-4909 APPROVED CHECKED PREPARED NAME Product Part Number: BATHV-00XXX-TPXX Product Description: BATTERY CONNECTOR SERIES Scope This specification covers performance, qualification plan and test method for BATTERY CONNECTOR SERIES the performances specified here under the condition with the battery connector Requirements Design and construction Product shall be of the design, construction and physical dimensions specified on the applicable product drawing. Materials and Finish See Drawing Ratings Voltage : 30 V AC/DC Current : 1A AC/DC Operating Temperature : -40℃ TO 85℃ Operating Humidity Range: 95% R.H. MAX. Test and Performance: Unless otherwise specified, all tests and measurements shall be performed under the following conditions in accordance with MILSTD Test Requirements and Procedures Summary ELECTRICAL No. Items Test Conditions Specifications 1 Examination of Product Product shall meet requirements of applicable product drawing and specification. Visual, dimensional and functional per applicable quality inspection plan. 2 Contact Resistance 30 m Ohm Max(Initial) 50 m Ohm Max(Final) Solder connectors on PCB and mate them together, measure by applying closed circuit current of 100mA maximum at open circuit voltage of 20mV maximum. [EIA-364-06] 3 Insulation Resistance 100 M Ohm Min. Mate connectors, apply 500V DC between two adjacent contacts for one minutes. [EIA-364-21] 4 Withstanding Voltage Test Connector must withstand test potential AC250V for 1 minute. No evidence of flash over or insulation shall take place. Mate connectors, apply AC250V (rms.) between two adj