specificationnumber260943.10.docVIP

Specification Number: 26 09 43.10 Product Name: NETWORK LIGHTING CONTROLS SECTION 26 09 43.10 NETWORK LIGHTING CONTROLS PART 1 - GENERAL Introduction The work covered in this section is subject to all the requirements in the General Conditions of the Specifications. The contractor shall coordinate all of the work in this section with all of the trades covered in other sections of the specification to provide a complete and operable system. Description of Work The extent of the lighting control system work is indicated by the drawings and by the requirements of this section. It is defined to include, but not by way of limitation: Lighting control panels containing line voltage rated relay and dimmers. Network devices to facilitate comunications with networks and between networks of lighting control devices. Network lighting control devices, including occupancy sensors, keypads, light level sensors, motion sensors, thermostats, touchscreens, modular relays, modular dimmers, modular input units and modular networking devices. Associated low voltage switches, occupancy sensors and external time clocks. Any work stations, software and communications hardware. System installation includes the following: Wiring of branch circuit and sub-circuit conductors to relay, dimmer and power supply modules. Installation of external control devices and interface with network lighting controls. Installation of communications conductors and associated hardware. Related Work Section 26 09 26 [Square D Powerlink] Lighting Control Panelboards Section 26 09 23 [Square D] Occupancy Sensors Quality Assurance Manufacturers: Firms engaged in the manufacture of lighting control equipment and ancillary equipment, of the types indicated, whose products have been in satisfactory use in similar service for not less than five years. Component Testing: All electronic component board assemblies are to be factory tested and burned in prior to installation. System Support: Factory fax/telephone/em