飞思卡尔单片机SCI通信选读.doc

SCI通信 一、飞思卡尔单片机DZ60 SCI通信 查询发送 #include hidef.h /* for EnableInterrupts macro */ #include derivative.h /* include peripheral declarations */ #define LED_D1 PTDD_PTDD0 #define LED_D1_DIR PTDDD_PTDDD0 #define LED_ON 0 #define LED_OFF 1 unsigned char SCANF_SEND_STRINGS[] = HELLO MCU WORLD; unsigned char *pSendString = SCANF_SEND_STRINGS; /*************************************************************/ /* 初始化总线时钟PEE模式 */ /* 外部晶振频率为4MHz，总线频率16MHz */ /*************************************************************/ void INIT_MCG(void) { MCGC2=0x36; while(!MCGSC_OSCINIT); MCGC1=0xb8; while(MCGSC_IREFST); while(MCGSC_CLKST!=0b10); MCGC2_LP = 1; MCGC1 = 0x90; MCGC3 = 0x48; MCGC2_LP = 0; while(!MCGSC_PLLST); while(!MCGSC_LOCK); MCGC1 = 0x10; while(MCGSC_CLKST!=0b11); } void delay(void) { unsigned int i; unsigned int j; for(i = 0; i 100; i++) for(j = 0; j 4000; j++); } void main(void) { DisableInterrupts; SOPT1 = 0; INIT_MCG(); EnableInterrupts; /* enable interrupts */ /* include your code here */ LED_D1_DIR = 1; LED_D1 = LED_OFF; //以下为设置波特率，以及初始化SCI1控制寄存器 SCI1BDH = 0X00; SCI1BDL = 0X68;//波特率设置为9600 SCI1C1 = 0x00; //设置SCI1为正常模式，八位数据位，无奇偶校验 SCI1C2 = 0x08; //允许发送数据，禁止中断功能 while(1) { while((*pSendString) != \0) { while(!SCI1S1_TDRE);//SCI1S1_TDRE 为1表示发送数据缓冲器为空 SCI1D = *pSendString; pSendString++; LED_D1 = ~LED_D1;;//每发送一个字节，闪烁一次LED灯 delay(); } } for(;;) { __RESET_WATCHDOG(); /* feeds the dog */ } /* loop forever */ /* please make sure that you never leave main */ （二）中断发送 #include hidef.h /* for EnableInterrupts macro */ #include derivative.h /* include peripheral declarations */ #define LED_D1 PTDD_PTDD0 #define LED_D1_DIR PTDDD_PTDDD0 #define LED_ON 0 #define LED_OFF 1 unsigned char SCANF_SEND_