MSR_Command.docVIP

MSR Command (all are hex code except where noted) 1. Write data Command: E7 55 AA E3 75 E3 Add E3 N E6 Data1 ... DataN Ack: FA FA FA FA FA FA FA FA FA FA FA ... FA * Ack is the acknowledge from the MSR Add is the start address of the EEROM N is the length of the writing data. 2. Read data Command: E7 55 AA E3 74 E3 Add E3 N E6 Ack: FA FA FA FA FA FA FA FA FA FA * Add is the start address of the EEROM N is the length of the data to be read. ** After MSR receives the command, it will output N*2 code, each EEROM data will be sent as two code, code1 is C0+(bit7-bit5), code2 is C0+(bit3-bit0). For example, data AB will be sent as CA, CB 3. Reset to defaut Command: E7 55 AA E3 60 E3 44 E6 Ack: FA FA FA FA FA FA FA FA New Commands Pass through command Cmd: E7 55 AA E3 7F E3 N E6 Ack: FA FA FA FA FA FA FA FA N=31, enter N=30, exit Write EEP command Cmd: E7 55 AA E3 80 E3 Add E3 Len E6 Ack: FA FA FA FA FA FA FA FA FA FA Code1 ... CodeLen ISP commands ISP MODE Cmd: E7 55 AA E3 7E E6 Ack: FA FA FA FA FA FA ISP program Cmd: E9 Add_H Add_L Code1 ... CodeLen Sum Ack: CA CA CA CA ... CA CA Ack Len=32 Ack = CB Good, Ack = CC Bad WHEN ADD=0000, ERASE ISP Start Cmd: E9 FF FF Add_H Add_L Sum_H Sum_L 00 (1) ... 00 (29) Ack: CA CA CA CA CA CA CA CA ... CA Add_H,Add_L is firmware length (29x00 is to make command len = ISP program) 28K 8000-EFFF file *.FWF len = 32 x N last two byte = check sum MSR EEROM Data Table Address: 00-FF Add Function ------------------------------------------------------------------------- 2 Beep settings bit 7 Good read beep 1/0 : yes/no ------------------------------------------------------------------------- 3-0E MSR prefix 12 bytes 0F-1A MSR suffix 12 bytes 1B-26 Track 1 preamble, Char