Cisco交换机安装配置.docVIP

Cisco2950交换机安装配置、故障排除手册 网络配置 ??2008-09-12 16:45 ??阅读121???评论0 ? 字号： 大大? 中中? 小小 ? 目??? 录 ? 第一部分?? 交换机安装. 2 1.1?? 安装前相关考虑. 2 1.2?? 在机架上固定交换机. 2 1.3?? 安装GBIC模块. 4 1.4?? 安装连接线缆. 5 第二部分?? 交换机基本配置. 8 2.1?? 加电后首次配置. 8 2.2?? 通过浏览器配置交换机. 9 2.3?? 通过CONSOLE口进入命令行配置. 11 第三部分?? 高级配置. 20 第四部分? ?安全配置. 22 第五部分?? 故障排除. 27 5.1?? 检查设备状态指示灯. 27 5.2?? 检查配置及相关信息. 29 5.3?? 已知的问题及解决方式. 33 第六部分?? 常见问题. 35 ? ? ? ? 第一部分?? 交换机安装 1.1?? 安装前相关考虑 Warning?： To prevent the switch from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of 113\xb0 F (45\xb0 C). To prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation openings。 Warning：? When installing the unit, the ground connection must always be made first ?And? disconnected last. 1.2?? 在机架上固定交换机 l????????? Attaching Brackets (Front Panel Forward) l????????? ?Attaching Brackets (Rear Panel Forward) l??????? Mounting the Switch in a Rack ? l??????? Attaching the Optional Cable Guide ? ? 1.3?? 安装GBIC模块 ? l????????? Installing a 1000BASE-X GBIC Module in the Switch? l????????? ?Installing a 1000BASE-T GBIC Module in the Switch l????????? ?Installing a GigaStack GBIC Module in the Switch 1.4?? 安装连接线缆 注意：交换机端口速率、双工的设置 ????????? Let the ports autonegotiate both speed and duplex. ????????? Set the port speed and duplex parameters on both ends of the connection. When connecting to workstations, servers, routers, and Cisco?IP Phones, connect a straight-through Category 5 cable to an RJ-45 connector on the front panel. ?When connecting to switches or repeaters, use a crossover Category 5 cable。 ? l????????? Connecting to a 10/100/1000 Switch Port The port LED is amber while Spanning Tree Protocol (STP) discovers the topology and searches for loops. This takes about 30 seconds, and then the port LED turns green. If the port LED does not come on, the device at the other end might not be turned on, or there might be a cable problem or a problem with the adapter