基于ARM热风监控系统研究设计书思考BasedonARMtheDesignofFurnaceMonitoringSystem.docVIP

摘 要 矿井加暖系统在矿产、冶金、化工等工业中具有广泛的应用。近年来,它以其风温高、投资少、易维护等优点在我国中型高炉中得到不断发展。热风炉风温控制水平也有了明显的提高,对高炉冶炼具有非常重要的影响及重大意义。 LPC2106是飞利浦带有一个支持实时仿真和跟踪的 ARM7DMI-S 微处理器，嵌入 128KB高速 Flash存储器。 采用3级流水线技术，取指、译码和执行同时进行，能够并行处理指令，提高CPU运行速度。由于具有非常小的尺寸和极低的功耗，非常适用于那些将小型化作为主要要求的应用。本文就是基于LPC2106的一个设计。 根据热效率、寿命、自动化程度等方面存在的问题，经过调查、分析和研究开发了一套新型矿用环保热风炉系统，该系统主要由数据采集系统、温度监测系统和主机控制系统三部分组成。 数据采集系统，要对复杂的现场环境进行监测控制，是整个新型热风炉自动控制系统的关键。温度监控系统，是用一个热电偶对炉内温度进行实时监控，通过A/D转换，将数据传给LPC2106通过数码管进行显示，再通过D/A转换对热风炉接口的实时控制。本文设计的数据采集系统由LPC2106、模拟量采集(A／D)、模拟量输出(D／A)、通信接口及其他辅助电路组成，结构简单、机构可靠性高，使用寿命长，能够对系统的各种现场数据进行实时监测和控制，对于矿井的安全可靠生产具有重要的意义。 关键词：热风炉，数据采集，输出控制，LPC2106 Abstract Mine calefaction system is broadly applied in industry， such as mine，metallurgy， chemistry industry and SO on．In recent years, with its high temperature, low cost, easy maintenance in blast furnace in medium. Hot air temperature control level has obvious increase of bf operation, and has important significance. Philips has a support LPC2106 is real-time simulation and tracking ARM7DMI - S 128KB embedded microprocessor, high Flash memory. Using 3 line technique, decoding and implementation, and at the same time, can improve the CPU commands, parallel processing speed. Because of the very small size and low power consumption, and is suitable for those who will be required, as the main application of miniaturization. This article is based on the design of a LPC2106. Life-span，degree of automation，we designed a new type of hot air furnace system which used in Mine and protect environment via research and analysis．The system is mainly constituted by data collection system， temperature—monitoring system and host computer controlling system． The data collection system is the key of entire new type hot air furnace automation controlling system， which monitor and control complicated locale circumstance．Data collection system designed in this paper is composed to singlechipLPC2106， simulating quantity collection(A／D)， simulating quantity output