Multicast Configuration.pptVIP

Multicast Configuration 1.0 Objective After this session, you will know: Basic multicast Configuration Advanced multicast Configuration Multicast Troubleshooting Contents of Course Multicast Commands Enter System View Enable Multicast routing multicast routing-enable Configure maximum routes in IP multicast forwarding table multicast forwarding-table route-limit limit-value Configure maximum downstream for each entry Multicast forwarding-table downstream-limit limit-value Multicast Commands Enter System View Configure IP multicast static route ip rpf-route-static source-address { source-mask-length | source-mask } [ protocol process-id ] [ route-policy route-policy-name ] { interface-name | gateway-address } [ order order-sequence ] [ preference preference-value ] Configure to select the longest matched route multicast longest-match ( default: route is selected by preference) Configuring IP Multicast Forwarding Scope Enter interface view Configure IP multicast forwarding scope multicast boundary group-address { group-mask-length | group-mask } Configure the minimum TTL of IP multicast forwarding multicast minimum-ttl ttl-value PIM-SM commands Enabling PIM-SM Enter system view Enter interface view pim sm Configuring C-BSR Position Enter pim view c-bsr interface-type interface-number Configuring BSR Service Boundary policy Enter interface view pim bsr-boundary bsr-policy acl-number PIM-SM Commands Configuring C-RP Position and RP Election Mechanism Enter the pim view Configure C-RP position c-rp interface-type interface-number [ group-policy acl-number ] [ priority priority- value ] [ holdtime hold-seconds ] [ advertisement-interval adv-seconds ] Configure static RP position static-rp rp-address [ acl-number ] [ preferred ] Enable receiving Auto-RP advertisement and discovery packets a