Chapter14 - WAN.docVIP

QUESTION 27 Which of the following describes the roles of devices in a WAN? (Choose three.) A. A CSU/DSU terminates a digital local loop. B. A modem terminates a digital local loop. C. A CSU/DSU terminates an analog local loop. D. A modem terminates an analog local loop. E. A router is commonly considered a DTE device. F. A router is commonly considered a DCE device. Answer: ADE QUESTION 114 When configuring a serial interface on a router, what is the default encapsulation? A. atm-dxi B. frame-relay C. hdlc D. lapb E. ppp Answer: C QUESTION 121 Which three options are valid WAN connectivity methods? (Choose three.) A. PPP B. WAP C. HDLC D. MPLS E. L2TPv3 F. ATM Answer: ACF QUESTION 122 Refer to the exhibit. Which WAN protocol is being used? A. ATM B. HDLC C. Frame Relay D. PPP Answer: C QUESTION 123 What is the difference between a CSU/DSU and a modem? A. A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line. B. A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line. C. A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line. D. A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line. Answer: D QUESTION 125 When troubleshooting a Frame Relay connection, what is the first step when performing a loopback test? A. Set the encapsulation of the interface to HDLC. B. Place the CSU/DSU in local-loop mode. C. Enable local-loop mode on the DCE Frame Relay router. D. Verify that the encapsulation is set to Frame Relay. Answer: A QUESTION 126 What occurs on a Frame Relay network when the CIR is exceeded? A. All TCP traffic is marked discard eligible. B. All UDP traffic is marked discard eligible and