公路扩建路基路面毕业设计毕业设计毕业.docVIP

PAGE 毕 业 设 计（ 论 文 ） 题目 作者 学院 专业 学号 指导教师 2014年4月 PAGE \* MERGEFORMAT i 摘　　要 本设计为初步设计，起点桩号K0+000.000，终点桩号K1+366.356，道路全长1366.356m。道路等级为城市次干道Ⅲ级，设计速度30km/h。设计主要包括路线平、纵、横设计，沥青路面设计，排水设计，平面交叉口设计等。 路线方案结合了规划蓝图，并对道路沿线做了实地考察，遵循城市道路设计的一般原则进行设计。竖曲线设计考虑了出行方便，故纵坡不宜过大，但因部分路段高差相对较大，以及路线两侧已有建筑物地坪标高的限制，所以纵断面设计中的最大纵坡达到了3.8%，对非机动车的行驶带来了一定的困难。 关键词：平曲线；路基；土石方；挡土墙；沥青混凝土；排水。  ABSTRACT This program was preliminary designed by ZhiZhi Lu in Hunan University of Science and Technology. Starting point stake number is K0+000.000, ending point stake number is K1+366.356 and the whole length of this road is 1366.356 meters. The road grade is urban secondary trunk, class Ⅲ, the design speed is 30km/h. This design includes routes` plane, longitudinal section and horizontal section, asphalt pavement, drainage design and intersection design. The scheme of this route combined the Long-term blueprint of Hunan University of Science and Technology and facilities along the road such as apartment of students, canteen, teaching buildings and so on. It follows the general principles of the urban road design. The design of vertical curve considered students` daily travel, so the longitudinal slope should not be too sharp. But on the other hand, parts of the route have large height differences, and the limit of the elevation of existing buildings along both sides, so, the maximum longitudinal slope is 3.8% and this more or less makes some trouble to non-motor vehicle driving. Key words: Horizontal curve, Subgrade, Earthwork, Retaining wall, Asphalt Concrete, Drainage.  PAGE \* MERGEFORMAT 59 目录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc326574916 第一章 前言 PAGEREF _Toc326574916 \h 1 HYPERLINK \l _Toc326574917 第二章 工程概况及设计标准 PAGEREF _Toc326574917 \h 3 HYPERLINK \l _Toc326574918 2.1 工程概况 PAGEREF _Toc326574918 \h 3 HYPERLINK \l _Toc326574919 2.1.1 路线起讫点 PAGEREF _Toc326574919 \h 3 HYPERLINK \l _Toc326574920 2.1.2 地形、地质、气候、水文等自然特征 PAGEREF _Toc326574920 \h 3 HYPERLINK \l _Toc326574921 2.1.3 施工条件 PAGEREF