UL标准解读.ppt

Requirements of UL 484 CSA C22.2 No. 117-1970 结构外壳防护 房间空调器壳体上开孔设计、定位应能减少与下述部件发生意外接触而可能发生危险： ①未绝缘高压带电部件。 ②运动部件，如风扇叶和风机叶片。 ③壳体内温度超过下表允许值的部件。 带电部件和运动部件的防护 ①沿试验指的主轴方向施加2.5磅（11.1牛）的力，②在开口所允许的任何位置及任何深度施加。在插入穿过开口之前、之中和之后，都应旋转或者改变试验指的角度，以使试验指伸到任何可能的位置。如果有必要，在试验指穿过开口之后，还要改变其形状。 漆包线的防护 短边尺寸应使用一个直径为1英寸（25.4毫米）的半球形顶端的试验指，以5磅（22.2牛）的力，不能穿过。 Enclosures 外壳 Among the factors which are taken into consideration when evaluating an enclosure are: a) Mechanical strength, b) Resistance to impact, c) Moisture-absorptive properties, d) Flammability, e) Resistance to distortion at temperatures to which the material may be subjected under conditions of use, and f) Resistance to corrosion. Polymeric Materials聚合材料 聚合材料的防火等级的要求 Polymeric parts which are depended upon for the direct support or isolation of electrical components and parts which are exposed to ignition sources within the unit shall be a 5V material. A polymeric material which does not comply with the flammability requirements for 5V materials shall be V-0, V-1, or V-2. Such materials shall not be used for direct support or isolation of wiring or electrical components. A V-0 or V-1 material may be used if it is not exposed to ignition sources. A V-2 material may be used if, in addition to being isolated from ignition sources in the same manner as V-0 and V-1 materials, there are no flammable materials, openings in the unit enclosure, or both, below the V-2 material within a volume defined by Space A of Figure 8.1. HB, HBF, and HF-1 materials may be used in the room air handling section of the unit only if all ignition sources in this section are completely enclosed in or isolated by metal or 5V material. ignition sources: High voltage uninsulated terminals, High voltage printed circuit board traces, High voltage open coils/windings, High voltage open contacts, and High voltage wiring not employing VW-1 insulation. Field Supply Connections电源线连接 A cord-connected single phase room air conditioner shall be provided with a fa