1001检验和试验控程序制程序.docVIP

1 目的Objective 对原材料、协配件、半成品、成品进行检验和试验，防止不合格的原材料、协配件非预期使用，不合格半成品转序，不合格成品出厂。 This is to inspect and test the raw material, components, semi-finished and finished products to avoid the nonconforming raw materials and components from unexpected usage, to avoid the defective semi-finished product from flowing into the next process and to avoid the defective finished product from releasing out of the factory. 2 适用范围Applicable Scope 适用于本公司的原材料、协配件、半成品、成品的检验和试验控制。 This is applicable to the control over the inspection and test of the raw materials, components, semi-finished and finished products of the company. 3 职责Responsibility 3.1 质量部负责原材料、协配件、半成品、成品的入库检验和验证的归口管理。 The Quality Department is responsible for the incoming inspection and test of the raw material, components, semi-finished and finished products. 3.2 技术工程部负责制订和发放原材料、协配件、半成品、成品的图样、检验规程及相关接收标准。 The Engineering Department is responsible to formulate and release the drawings, inspection procedures and relevant receiving standards applicable to the raw materials, components, semi-finished and finished products. 4 工作程序Work Procedures 4.1 检验和试验前的准备Preparation Prior to the Inspection and Test 4.1.1 由质量部根据《控制计划》和检验指导书，在开始检验工作之前，复查是否已经对每项重要检验项目的方式和方法做出规定，其内容包括：检验方法、检验工具及精度、抽样方法、评定方法、记录方法，注明可能需要提供的质量保证书/自检报告、要求和验证方式。 Prior to inspection, the Quality Department shall refer to the “Control Plan” and Inspection Instruction, checking if the inspection way and method for each important item have been regulated, including: inspection approach, inspection tools and their precision, sampling method, assessment approach and recording method, as well as the remarks on necessary quality warranty/self-inspection report, requirements and verification way. 4.1.2 在制订计数特性数据接收抽样计划时，接收准则必须是C=0抽样计划。 When formulating the sampling plan for the receipt of counting characteristic data, the principle of receipt must be C = 0 sampling plan. 4.1.3 检验方式Inspection Approach 抽检：检验员对原辅料、协配件、半成品、成品的抽样检查。 S