ADI in DBF Ultrasound block diagram.pptVIP

Dec2005 ADI Confidential Information ADI in Ultrasound Application2009 ADI Changes the Game through IntegrationAD927x – Complete 8-channel Single-chip AFE AD9272 – Integrated Octal SolutionLNA + VGA + AAF + 12 Bit ADC KEY BENEFITS (PRELIMINARY) 8 channels of LNA, VGA, AAF, and ADC Low noise preamplifier (LNA) Input-referred noise = 0.75 nV/√Hz (gain = 21.6 dB) @ 5 MHz typical SPI-programmable gain = 15.6 dB/18.1 dB/21.6 dB Single-ended input; VIN maximum = 733 mV p-p/ 550 mV p-p/367 mV p-p Dual-mode active input impedance matching Bandwidth (BW) 70 MHz Full-scale (FS) output = 4.4 V p-p diff Variable gain amplifier (VGA) Attenuator range = ?42 dB to 0 dB Postamp gain = 21 dB/24 dB/27 dB/30 dB Linear-in-dB gain control Antialiasing filter (AAF) Programmable 2nd-order LPF from 8 MHz to 18 MHz Programmable HPF Analog-to-digital converter (ADC) 12 bits at 10 MSPS to 80 MSPS SNR = 70 dB SFDR = 75 dB Serial LVDS (ANSI-644, IEEE 1596.3 reduced range link) Data and frame clock outputs 8-channel cross-point switch to support continuous wave (CW) Doppler Low power, 200 mW/channel at 12 bits/40 MSPS (TGC) 100 mW/channel in CW Doppler Flexible power-down modes Overload recovery in 10 ns Fast recovery from low power standby mode, 2 μs 100-lead TQFP AD9272 VGA Gain Requirements AD9272 AD9273 Configuration Tool AD927x Gain setting table Power and Speed Grades 32 Channel CW – Doppler Configuration with AD9272 AD8339 AD8339 – Low Power Quad IQ Demodulator Phase Shifter Key Features Quad Integrated I/Q Demodulator 16 Phase Select on each Output Quadrature Demod Accuracy LO RF Bandwidth – LF - 25 MHz Baseband Bandwidth 500 kHz (determined by external filtering) Supply: ±5 V Power Down SPI Interface Applications (General Purpose) Medical Imaging (CW Ultrasound Beam Forming) Phased Array Systems Radar Adaptive Antennas Communication Receivers AD8333 –IQ Demodulator Phase Shifter Key Features Dual Integrated I/Q Demodulator 16 Phase Select o