操作手册Operation Manual6p.docxVIP

操作手册Operation Manual操作手册Operation Manual监控电脑的开启按电脑上的电源键，电脑会自动启动直至出现登陆的对话框，在对话框的用户名内填入“operator”直接敲击回车键就会自动进入操作员权限的主画面，如下图：1. The opening of the monitoring computerPress the power button on the computer, and the computer will automatically start to login dialog box, then enter the user name of “operator” in dialog box and directly hit Enter key, and then the computer will automatically enter the main screen of operator authority, as shown in the following figure:（图-1）(Figure-1)如果在对话框的用户名内填入“Administrator”进入工程师权限操作的时候是需要密码的，这个密码会随资料一起交付给相关人员。If the dialog box is filled in the user name of “Administrator” to enter engineer authority s need a password, the password will be with the data delivery to the relevant personnel.监控画面的说明2. Note for monitor screen1、点击图-1中的“HP BOILER”，就会进入20T HP boiler的监控界面，如图-2所示，在画面上可以之间 看到锅炉的所有的温度、压力、流量、阀门开度、变频器频率等数据的检测值，在图-2所示的红色字体的闪烁代表的是报警，有相应的英文所显示。1. Click the HP BOILER” in Figure 1, and enter 20T HP boiler monitoring interface on the screen, as shown in Figure -2, then, all data of detection values, such as boiler temperature, pressure, flow rate, the valve opening and the inverter frequency can, etc, can be seen. The flashing red font shown in Figure -2 represents alarm, with the corresponding English displayed.在图-2所示绿色圆圈代表电机正运行着，如果显示是红色代表电机停止运行，如果显示是黄色，代表电机故障或MCC抽屉没有合闸。“BC054”为电机的位号，“Ash conveyor”为测点的名字，在键盘上敲击”N”键可以让这个名字出现或不出现。2. Green circles shown in Figure -2 represent that the motor is running, if the display is red, it means that the motor stops running; if the display is yellow, it means motor failure or MCC drawer is not closing. BC054 is the bit number of the motor, Ash conveyor is the name of measuring point, and hitting N key can let the name appear or not appear.在图-2中所示 “PR19822”为测点的位号，“1.1”为实际现场的测量值，“Bar”为测点的量程单位，“Feed water pressure”为测点的名字，在键盘上敲击”N”键可以让这个名字出现或不出现。3. PR19822 shown in Figure -2 is the bit number of the measuring points, while“1.1”is the measured value of the actual scene. Bar is the measuring range unit of mea