USB3.0 spec.docVIP

USB 3.0 Dock Required devices Device Part Number HP Required ODM Notes Comments USB-Video Controller DisplayLink DL-3900 USB-Audio Controller DisplayLink DL-3900 USB to Ethernet controller DisplayLink DL-3900 4 Port USB 3.0 Hub TI TUSB8040 Audio components Refer to item 5 below. ODM shall specify part numbers for each of these components. Device Vendor/ Part Number ODM Notes Comments 4 Port USB 2.0 Hub The mechanical drawings shall include a 3 view (top, side, front) 2D drawing that includes all of the features listed below. ? I/O Connectors ? Docking cable/connector ? Notebook support and viewing height/angle adjustment mechanism ? Drive bay placement and access ? Internal speaker enclosure outlines ? System PCB Category Base Specification Reference document ODM Notes Comments Agreement at Award 1. Footprint and ID Stand Alone Port Replicator, ID shared with Adriatic 2.0. 2. Branding “HP USB 3.0 Dock” (actual text TBD) must appear in Device Manager 3. Standard I/O Ports Connectors (for the Port Expander Module). 2 USB 2.0 ports are located on the front of the unit. The rest of the I/O ports are located on the back. (2) USB 3.0 ports from internal Hub. Total current shared among USB ports should be 2.5 amps continuous current. (4) USB 2.0 ports from internal Hub; 2 ports on the front and 2 ports on the back of the unit. A total of 20W +5V power is allocated for the USB ports. The ports are always powered (even when no notebook is present). (1) RJ45 LAN output (10/100/1000) (1) Microphone input jack (stereo) (1) Headphone out jack w/jack sense to mute internal and notebook speakers, located adjacent to Microphone. (1) DisplayPort monitor output (1) HDMI monitor output Inputs to dock: (1) type “B” USB 3.0 input to hub; for connection to the notebook. (1) AC Adapter Jacks:19v, 3-pin (“Smart Adapter”) type. ESD protection; 8KV contact and 12KV air discharge to input pin or antenna, with no damage, degradation of performance, or change of charact