FURUNO GPS NAVIGATOR GP-150 安装手册以及操作手册1.pdfVIP

INSTALLATION MANUAL GPS NAVIGATOR GP-150 1. SYSTEM CONFIGURATIONS 1 2. EQUIPMENT LIST 2 3. DISPLAY UNIT 4 4. ANTENNA UNIT 6 5. WIRING 10 6. INITIAL SETTINGS 12 7. OPTIONAL DGPS 23 PACKING LISTS INSTALLATION MATERIALS A-1 OUTLINE DRAWINGS D-1 INTERCONNECTION DIAGRAM S-1 SAFETY INSTRUCTIONS WARNING Do not work inside the equipment unless totally familiar with electrical circuits. Hazardous voltage which can cause electrical shock, burn or serious injury exists inside the equipment. Turn off the power at the mains switchboard before beginning the installation. Post a sign near the switch to indicate it should not be turned on while the equip- ment is being installed. Fire, electrical shock or serious injury can result if the power is left on or is applied while the equipment is being installed. Ground the display unit to prevent loss of sensitivity and mutual interference. Confirm that the power supply voltage is compatible with the voltage rating of the equipment. Connection to the wrong power supply can cause fire or equipment damage. The voltage rating appears on the label at the rear of the display unit. Use the correct fuse. Use of a wrong fuse can cause fire or equipment damage. Keep the following compass safe distances: Standard Steering Display unit 0.50 m 0.35 m CAUTION This page is intentionally left blank. 1 1. SYSTEM CONFIGURATIONS Antenna Unit GPA-018S* Display Unit Radar, Echosounder, Autopilot etc. DGPS Beacon Receiver GR-80** 12-24VDC Antenna Unit GPA-017S**Antenna Unit GPA-019S* *: w/internal beacon receiver **: w/o internal beacon receiver 2 2. EQUIPMENT LISTS Standards Name Type Qty Remarks GPA-017S GPA-018S Antenna Unit GPA-019S 1 For DGPS GP-150-E-N Without Beacon RX Display Unit GP-150-E-A 1 With Beacon RX CP20-01900 With Antenna Cable Installation Materials CP20-01950 1 set See lists at end of manual. Without A