ATVQATVQ推广手册(英文).docVIP

 IP23 „Basic design“ Typical applications  HHP frequency inverter in an enclosure for installation in electrical rooms  HHP frequency inverter in an enclosure for installation in operating rooms with moderate dust exposure  Ambient temperature: 0...+40°C (-10...+40°C with enclosure heating)  Ambient temperature up to +50°C with derating Principle design The fan of the power part, which is inside the device, provides the forced cooling of the inverter and the heat abstraction of the enclosure. The cooling air is supplied by a grill in the enclosure door with large surface. For the air outlet, a cut-out in the roof sheet of the enclosure is provided and an air guidance hood is mounted onto it. The installation of the frequency inverter into the enclosure can be realized with a DCL box at the top side of the inverter or with a line reactor below the inverter. 1. Enclosure 2. Frequency inverter Altivar 61 or Altivar 71 3. DCL box (only available for 400V product lines) 4. Power part components (main switch, line contactor, chokes,…) 5. Air inlet grid (without filter mat) for control part and power part 6. Guided air flow (air channel) to avoid internal air short-cuts 7. Air guidance hood with splash water protection Main parts of these cooling systems are the guided air flow inside the enclosure (air channel between inverter/DCL box and the roof sheet of the enclosure) and the air guidance hood mounted outside. On the one hand, an internal air short-cut is prevented and on the other hand the specifications for IP 23 are fulfilled. The air exchange takes place by the inlet grill (without filter mat!) in the enclosure door and the cut- out in the roof sheet to the air guidance hood. This cooling system does not need additional fans in the enclosure. The fan of the control part as well as the fan of the power part inside the inverter provide the required air flow. The forced cooling of the power part components, which is built-in below the inverter, is also very ad