摩托车光导前位置灯的结构设计论文概览.docx

PAGE \* MERGEFORMATII 摩托车光导前位置灯的改装设计 专业：机械设计制造及其自动化 班级：122班 姓名：丁大君 指导教师：江洁 摘要 摩托车的使用是非常方便的，因此十分受到大家的欢迎。而本文研究的摩托车位置灯是摩托车车灯中非常重要的一种。位置灯是在光线较暗时用来标志车辆的形位，给行人或其他车辆起警示作用，避免看不见而发生危险。本文设计的位置灯是采用LED颗粒发光，通过光导管将光传导输出，解决传统车灯亮度低，方向性差等问题，但LED车灯散热严重，于是采用结合铝基板和驱动电路板分离的结构，大大的降低了LED颗粒由于热量集中而导致的失效或光输出下降的问题，其结构可以满足GB17510-2008《摩托车光信号装置配光性能》要求。 关键词 LED车灯 光导管 铝基板 散热 摩托车 Modification design of position lamp for motorcycle Profession: mechanical engineering and automation Class:jizi122 Name : Ding Dajun instructor : Jiang Jie Abstract As a simple means of transport, the motorcycle is very popular now. In this paper, the position lamp of motorcycle is a very important one. The position lamp is used to mark the shape of the vehicle when the light is dark, Position lamp, instrument lighting lamp and license plate lights at the same time, in order to mark the vehicles shape, to indicate the width of the car to remind each other and after the car which can warn other vehicles to avoid danger. In this paper, the design of the position lamp is the use of LED particles of light, through the light guide tube to the output, to solve the traditional lamp brightness low, poor direction and other issues. Although the light pipe front position lamp it has advantages of good monochromaticity, good directivity, high brightness, good coherence, but it has its limitations. But LED lamp cooling is serious, so the use of combination of aluminum substrate and drive circuit board separation structure, greatly reduce the LED particles due to the heat concentration caused by failure or light output decline. The structure can meet the requirement of GB17510-2008 light signal matching performance of motorcycle. Keywords LED lighting Light guide tube Aluminum substrate dissipate heat motorcycle  Ⅲ 目 录  TOC \o 1-3 \h \z \u  HYPERLINK \l _Toc451252438 摘要 Ⅰ  HYPERLINK \l _Toc451252439 ABSTRCCT Ⅱ  HYPERLINK \l _Toc451252440 第一章 绪论 1  HYPERLINK \l _Toc451252441 1.1 课题背景及意义 1  HY