com-tank-5.docVIP

Transition #1 ASME Section VIII Division 1, 2001 Edition, A03 Addenda Component:TransitionMaterial specification:SA-516 70 (ASME II-D p. 14, ln. 31)Material impact test exemption temperature from Fig UCS-66 Curve B = -27.72778 °CFig UCS-66.1 MDMT reduction = 13.88889 °C, (coincident ratio = 0.749965)UCS-66 governing thickness = 0.3937008 in (10.00 mm)Internal design pressure: P = 1000.0001 kPa @ 80.00°C External design pressure: Pe = 103.4214 kPa @ 80.00°C Static liquid head: Ps=7.2278 kPa(SG=1.0000, Hs=737.64 mm Operating head at small end)Ps=19.4758 kPa(SG=1.0000, Hs=1987.64 mm Operating head at large end)Pth=7.2278 kPa(SG=1.0000, Hs=737.64 mm, Horizontal test head at small end)Pth=19.4758 kPa(SG=1.0000, Hs=1987.64 mm, Horizontal test head at large end) Corrosion allowance:Inner C = 0.00 mmOuter C = 0.00 mm Design MDMT = 0.00°CNo impact test performedRated MDMT = -41.61°CMaterial is not normalizedMaterial is not produced to Fine Grain PracticePWHT is not performed Radiography:Category A joints -Full UW-11(a) Type 1Circ. joint top/left -Full UW-11(a) Type 1Circ. joint right/bottom -Full UW-11(a) Type 1 Estimated weight: New = 330.0 kg corr = 330.0 kgCapacity: New = 689.9 liters corr = 689.9 litersAxial length = 1202.00 mmLarge End ID = 1400.0000 mmSmall End ID = 150.0000 mmCone tc = 10.00 mm Design thickness, (at 80.00°C) UG-32(g) (Large End) t=P*D / (2*Cos(?)*(S*E - 0.60*P)) + C=1019.4758*1400.0000 / (2*Cos(46.121468)*(137895.1400*1.00 - 0.60*1019.4758)) + 0.0000=7.50 mmSmall End design thickness (t = 0.79 mm) does not govern. MAWP, (Corroded at 80.00°C) UG-32(g) (Large End) P=2*S*E*t*Cos(?) / (D + 1.20*t*Cos(?)) - Ps=2*137895.1400*1.00*10.0000*Cos(46.121468) / (1400.0000 + 1.20*10.0000*Cos(46.121468)) - 19.4758=1337.8813 kPaSmall End MAWP (12067.1731 kPa) does not govern. MAP, (New at 21.11°C) UG-32(g) (Large End) P=2*S*E*t*Cos(?) / (D + 1.20*t*Cos(?)) - Ps=2