DIY式STX-501H密码频率快速拷贝遥控器说明书.doc

301H-2H Code / Frequency Simultaneously Learning [1]. Transmission Frequency Range: 250-450Mhz Pressing any one channel button, LED lights on solid。 [2]. To activate Code / Frequency Learning Mode Press and hold buttons 1+2 together, count LED flashing LED Flashes once then release – Transmission mode LED Flashes twice then release – Learning mode [3]. To Proceed Code / Frequency Learning --Code Learning mode As sketch (1) ; Hold original (Old) transmitter at Left hand side and 301H-2H at Right hand side. a). Keep 15cm distance between Old TX (transmitter) and 301H-2H b). Pressing button 1. of Old TX and 301H-2H together at the same time. c). 301H-2H flashes twice and goes off, d). Now slowly move the Old TX to right hand side and stop moving when the LED of 301H-2H is on solid. e). Still pressing holding 3 seconds after the LED of 301H-2H goes off then release your hand. Code/frequency learning is complete for button 1. f ). Button 2 or 3… please proceed the steps as a) …e) Remark : [A]. If code/frequency learning of 301H-2H is not successful from the above proceeding, please change the position of Old TX as sketch (2) and starting again from steps a)…e) . [B]. Step b.) – If LED of 301H-2H lights ON, 301H-2H is not under Code/Frequency Learning mode, please proceed step [2] again. [C]. A/B section switch: Turn switch up at A. section – 2 channels are able to learn 2 different codes frequencies Turn switch down at B section–2 channels are able to learn 2 different codes frequencies [D]. It will skip out the ‘Learning Mode’ if pressing any buttons over 4 times. Please renew to enter the Sketch (2). Sketch (1). ‘learning mode’ and do the procedures again for completing duplication.  ` SIMPLY OPERATION INSTRUCTION Press and hold buttons 1+2 together, count LED