epoxyfiberglasspipewraprepairdirection-SNOPSIS.PDFVIP

Epoxy Fiberglass Pipe Wrap Directions How to do an epoxy and fiberglass cloth pipe wrap repair. SNOPSIS: Using epoxy and fiberglass cloth to create an protective wrap around piping and tubing in a workplace environment. Pipe wrapping directions. Keywords: epoxy, pipe wrap, pipe repair Value Based Epoxies Progressive Epoxy Polymers, Inc. 48 Wildowood Drive Pittsfield, NH 03263 info@ PIPE WRAP SYSTEM For Use With Wet/Dry 700, CorroCoat FC 2100 and Quick Fix Epoxies The procedures described below will allow the installation of an impermeable, tightly adherent glass fiber reinforced laminate over pipes. Supplies Required 1. Gloves, long sleeved, rubber. Fairly thin rubber gloves such as single use examina- tion gloves or “PlatexTM” brand household gloves are preferable to thick industrial types. 2. Paint spreaders. Plastic or metal straight-edged spreaders are required for the application of the epoxy material. 3. Paint mixing. Wooden paint store type mixers are required for preparation of the epoxy mixes. 4. Paint mixing surface. Cardboard, fiberboard, plywood etc. Should be disposable. 5. Scissors. Sharp scissors for cutting the fiberglass tape. Introduction The epoxy material specified for use with fiberglass tape is a 100% solids, wet surface tolerant, KevlarTM reinforced epoxy material suitable for exposure to a wide range of industrial chemicals. Procedures using epoxy 1. Surface preparation A. For insulated pipes with corrosion-under-insulation present 1. Remove insulation from 8 (20 cm) full diameter around the damaged area. 2. Abrasive bl