某药用瓶盖的注塑模设计汇编.docVIP

本科生毕业设计（论文） （ 20 届） 设计（论文）题目 某药用瓶盖的注塑模设计 作 者 陆博文 分 院 钱江学院 专 业 班 级 机械专业091班 指导教师（职称） 马宝丽 论 文 字 数 11000字 论文完成时间 2013年4月23日 杭州师范大学钱江学院教学部制 某药用瓶盖的注塑模设计 机械专业091班陆博文 指导教师 马宝丽 摘要：通过分析间断型某内螺纹瓶盖的工艺性，可知内螺纹为半圆型螺纹，由于该瓶盖的材料为聚苯乙烯（PS），该材料不宜采用强制脱模。所以塑件采用内抽芯机构进行脱模，由零件图可知，内螺纹为两个局部段，对应在模具上制成两个内抽的滑块。当动定模分型时，在连接推杆的作用下，八个成型螺纹滑块沿T形槽移出，产生向心的收拢运动。这些滑块始终不脱离型芯座。由于瓶盖的上部分要求严格，所以采用点浇口浇注系统，脱模后不在修正浇口的痕迹。但采用这种浇口时，常常要在模具上增加一个分型面，以便浇口凝料脱模。 关键词：螺纹滑块；内抽芯；点浇口； Design of injection mold for a medicinal bottle Electronic information engineering class 091 Lu Bowen Instructor: Ma baoli Abstract:Pass the analysis interrupteds the craft of a cover of thread inside the type, can know is a thread of semicircle inside the thread, because of in order to gather the styrene( PS), that bottle of material for cover that material should not adopt to take off the mold compulsory.So an adoption ofinside take out the organization ofto carry on taking off the mold, can know from the diagram, inside the thread is two partial segment, in molding tool ascend make into twoth to should take out of slippery piece.When move to settle the type of cent of mold, while link the function of push the pole, eight model the thread the slippery piece follows the T form slot to move, producing to accept the sport of centripetally.These slippery pieces do not escape from a always.Because the upper part of a cover requests separately strictly, so the adoption orders to sprinkle to sprinkle to note the system, after taking off the mold not sprinkle the oscular trace in the correction.But adopt this kind of to sprinkle, usually want to increase the type of a cent to face on the molding tool, in order to sprinkle a peopleto anticipate to take off the mold. Keyword:Slippery piece of thread; Inside take out;Order