HSC-01转角油缸.pdf

TAIWAN AMAC CLAMP INDUSTRIAL CO., LTD. TEL:886-4FAX:884-4Hydraulic Swing Clamp Cylinder ? Bore:?25-?63mm ? Pmax:100kg/cm 2 ? MC ? ? , ? 1.5 ? Product Introduction ? The product is ideal for mass production on a special purpose machine and jig on machining center. It will greatly upgrade production efficiency. ? When the hydraulic cylinder actuate, and the piston moves downward, the clamping arm will swing to a rated angle. Then it lowers until the workpiece is clamped securely. ? To avoid too fast motion a flow control valve is suggested to connect to the hydraulic swing clamp cylinder. Do not clamp workpiece while the calmp is swinging to avoid damaging on the cylinder barrel and internal parts. ? When increasing length of clamping arm is required, be sure do not exceed 1.5 times of the original length. ? The cylinder body is manufactured from structural carbon steel. Surface is specially treated for maximum smoothness on inside surface and long service life. Specifications Bore of cylinder mm ?25 ?32 ?40 ?50 ?63 Piston rod diameter mm ?18 ?20 ?22.4 ?28 ?35 Swing stroke mm 9 11 11 13 13 / Clamping stroke std/Incr mm 13 15 / 30 15 / 30 17 / 34 17 / 34 / Pressure area pull/push cm 2 2.37 / 4.91 4.9 / 8.04 8.63 / 12.57 13.47 / 19.63 21.55 / 31.17 Theoretical clamping 30kg/cm 2 71 147 259 404 647 Fluid Filtered hydraulic oil Max operation pressure 100Kg/cm 2 Operation pressure range 5-70Kg/cm 2 Rotating direction R L Turn right R or turn left L Rotating angle 90 0o. 45o . 60o Standard angle 90o, Optional angle 0o, 45o, 60o Acting type Double acting HSC Ordering Code Series Bore of Cylinder Clamping arm type 25:?25mm 32:?32mm 40:?40mm 50:?50mm 63:?63mm Type Rotating Direction N:0? N:0? No swing L L: Turn left R R: Turn right S: S: Single side arm D: D: Double side arm : Blank:Line type MF MF:Manifold with flow control M: M: Manifold type TB: TB: Threaded body FA: FA: Flange type HSC MF 25 S R 90 FAM: FAM: Flange with manifold Rotating Angle