数控系统现场总线可靠通信机制的_王志成探究.pdfVIP

第 47 卷第 3 期 2011 年 2 月 机 械 工 程 学 报 JOURNAL OF MECHANICAL ENGINEERING Vol .47 No .3 Feb. 2011 DOI：10.3901/JME.2011.03.152 数控系统现场总线可靠通信机制的研究* 王志成 1, 2 于 东 2 张晓辉 1 胡 毅 1 李培新 1 陈 猛 3 (1. 中国科学院研究生院 北京 100039； 2. 中国科学院沈阳计算技术研究所高档数控国家工程研究中心 沈阳 110171； 3. 沈阳高精数控技术有限公司 沈阳 110171) 摘要：现场总线的应用是数控系统发展的必然趋势。为满足数控系统的高可靠通信需求，在分析数控系统加工精度与可靠通 信关系的基础上，设计一种现场总线可靠通信机制。针对该机制，建立数控系统通信可靠性评价的指标，提出以无故障通信 时间来衡量现场总线通信的可靠程度；通过概率统计方法，对该机制的可靠性进行数学分析，得出现场总线通信可靠性与通 信站数目及最大重发次数的关系，并分析各自的影响程度；通过仿真试验，验证理论分析结果的正确性，同时将该可靠通信 机制应用到数控系统现场总线中，通过实际电磁干扰测试，证明该机制的有效性。该理论研究和试验结果，对数控系统通信 的可靠性设计和分析具有重要的指导作用。 关键词：数控系统 现场总线 可靠通信 可靠性评价 可靠性分析 中图分类号：TP393 Study on Reliable Communication Mechanism of Field-bus for Numerical Control System WANG Zhicheng1, 2 YU Dong2 ZHANG Xiaohui1 HU Yi1 LI Peixin1 CHEN Meng3 (1.Graduate University, Chinese Academy of Sciences, Beijing 100039; 2. National Engineering Research Centre for High-end CNC, Shenyang Institute of Computing Technology, Chinese Academy of Sciences, Shenyang 110171; 3. Shenyang Golding NC Tech. Co., Ltd., Shenyang 110171) Abstract：Field-bus application is an inevitable development trend of numerical control (NC) system. In order to meet the NC system’s high demand for reliable communication, based on the analysis of relationship between machining accuracy of NC system and reliable communication, a reliable communication mechanism of field-bus is designed. For this mechanism, an evaluation indicator for the communication reliability of NC system is established, and it is proposed that the fault-free communication time is used to measure the reliability of field-bus communication. Then by using the probability statistics method, mathematical analysis of the mechanism reliability is carried out, and the relation between the field-bus communication reliability and the number of communication stations and the maximum times of retransmissions is obtained, and their respective influence degree is anal