壓型钢板组合楼板.pptVIP

Chapter 3 Composite floor with steel profiled压型钢板-混凝土组合楼板 ;OBJECTIVE/SCOPE To describe the design of one-way spanning composite slabs, formed using profiled steel sheeting and a concrete topping, including consideration of ultimate and serviceability limit state design for building structures. 压型钢板、压型钢板分类 压型钢板-混凝土组合楼板 应用范围 设计方法 构造;3.1 Introduction;Composite slab with profiled steel sheet;;Profiled Steel sheeting(a pattern of ‘embossments’) 板面的齿槽与压痕可提供界面粘结力；界面的摩擦粘结等 ;Construction stage: place the profiled steel sheeting over the support beams ;Construction stage: weld studs through the steel sheeting with portable welding gun;Construction stage: place the light steel reinforcement/ steel mesh;Construction stage: cast concrete;Types of Profiled Sheet压型钢板类型;Trapezoidal types开口型压型钢板; Advantages identified as the follows: The steel deck acts as permanent shuttering for the in-situ cast concrete slab, with a consequent saving in time and labor. It once in position, immediately provides a platform to support construction loads and a safe, sturdy working surface. It acts as the tensile reinforcement. The steel deck geometry can result in a reduction of labor about 30% in the amount of concrete fill required for the floor, significant reduction in dead weight loads .;3.2. DESIGN PRINCIPLES 设计验算;a) Steel deck shuttering（施工阶段） Verifications at the ultimate limit and serviceability limit states are required, with respect to the safety and serviceability of the steel deck acting as formwork for the wet concrete. The effects of any temporary props used during execution, must be taken into account in this design situation. b) Composite slabs （正常使用阶段） Verifications at the ultimate limit and serviceability limit states are required, with respect to the safety and the serviceability of the composite slab after composite behaviour has commenced and any props have been removed.; 设计考虑因素：Three major aspects identified for consideration during the design of a composi