基于s7300plc的煤矿井下中央泵房控制-学位论文.docVIP

山东科技大学学士学位论文 摘要 摘要 本文对煤矿井下中央泵房控制系统的硬件系统设计、软件系统设计以及系统的抗干扰措施进行了详细设计。本系统采用SIEMENS的S7-300 PLC，并结合各种传感器（主要为水位传感器、负压传感器、压力传感器、流量传感器、振动传感器、温度传感器等），完成系统中要实现的控制方式选择、故障报警等功能。本系统采用水泵及管路的“自动轮换”工作制。采用台达人机界面就地监控系统中设备的参数，并进行现场的就地手动控制，做到有故障及时发现并尽早处理。S7-300 PLC采用RS485通信标准与地面监控中心上位机进行通信，对排水系统实施全面的监控，并能进行远程控制。 关键词：PLC 传感器 排水系统 自动控制 ABSTRACT In this paper, the selection and design of drainage equipment, then according to the drainage control requirements, the design of automatic control. The system uses the SIEMENS S7-300 PLC, and combined with a variety of sensors (mainly for the water level sensor, pressure sensor, pressure sensor, flow sensor, vibration sensor, temperature sensor), control mode to achieve the system choice, alarm and other functions. This system uses the water pump and pipeline turns working system. A valley principle to determine the number of the opening pump according to avoid peak, in order to achieve the purpose of saving the power. The parameters of the equipment of delta HMI monitoring system of in situ PC end, and local manual control site, do have the fault timely detection and early treatment. S7-300 PLC communication using RS485 communication standard and the ground control center PC, the implementation of a comprehensive monitoring of the drainage system, and is capable of remote control. Keywords：PLC  HYPERLINK /s?wd=sensor \t _blank sensor  HYPERLINK /s?wd=drainage%20system \t _blank drainage system automatic control山东科技大学学士学位论文 目录 目录山东科技大学学士学位论文 目录  TOC \o 1-2 \u 1 绪论  PAGEREF _Toc359172427 \h 1 1.1 课题的研究意义  PAGEREF _Toc359172428 \h 1 1.2 国内外研究现状  PAGEREF _Toc359172429 \h 1 1.3 课题主要研究内???  PAGEREF _Toc359172430 \h 2 2 系统总体设计  PAGEREF _Toc359172431 \h 3 2.1 课题设计要求分析  PAGEREF _Toc359172432 \h 3 2.2 课题设计功能分析  PAGEREF _Toc359172433 \h 4 2.3 硬件和软件功能划分  PAGEREF _Toc359172434 \h 7 3 系统硬件设计  PAGEREF _Toc359172435 \h 9 3.1 CPU的选型  PAGEREF _Toc359172436 \h 9 3.2 传感器的选型设计  PAGEREF _Toc359172437 \h 10 3.3 开关量输