The main bod construction stage of level measurementThe main body construction stage of level measurement.doc

The main body construction stage of level measurement 1, to the construction drawings given elevation as level elevation according to 0.00 mm, irfpa from building to building measurement and transmission parts, upward elevator well, pipe well inside the wall (not less than two) be clearly marked as upward putright elevation according to the structure construction, each floor elevation to basis as an original point in the 50 m steel rule after check up measurement, and tag them as the layer of the level elevation. 2, this project because the area is larger, putright points based on multiple level in the construction, so we must adopt closed legal check multiple levels according to some rules construction survey. 6.2.1.1.6 building settlement observation Building settlement observation to execute the ministry of construction building deformation measurement procedures JGJ8-2007. According to the deformation measurement level 2 technical requirements. (note: the procedures article at 2.0.5 regulation, primary sedimentation observation point elevation difference error ≦ 0.15 mm, height of secondary sedimentation observation point error ≦ 0.50 mm, consider instrument rating on the construction site, in accordance with the requirements for measuring secondary sedimentation observation) 6.2.1.1.6.1 point layout Point layout as shown in the settlement observation point layout table. The name of the point request number Reference point deformation influence beyond, to long-term preservation of stable position monitoring point 2 Work basis points close to the observation point, easy observation of a stable position since settlement observation point 4 Observation point can reflect the characteristics of the building settlement points to determine the building settlement Using the known level point or settlement has stable buildings built. Scene four heads of leveling points as a work basis points. Outside the observation point layout in building large Angle and eav