110kv变电站电气主接线设计_学位论文.docVIP

摘要 Ⅰ 摘 要 根据设计任务书的要求，本次设计为110kV变电站电气主接线的初步设计，并绘制电气主接线图。该变电站设有两台主变压器，站内主接线分为110kV、35kV和10kV三个电压等级。110KV电压等级采用双母线接线，35KV和10KV电压等级都采用单母线分段接线。 本次设计中进行了电气主接线的设计、短路电流计算、主要电气设备选择及校验（包括断路器、隔离开关、电流互感器、电压互感器、母线、熔断器等）、各电压等级配电装置设计。 本设计以《35～110kV变电所设计规范》、《供配电系统设计规范》、《35～110kV高压配电装置设计规范》等规范规程为依据，设计的内容符合国家有关经济技术政策，所选设备全部为国家推荐的新型产品，技术先进、运行可靠、经济合理。 关键词：降压变电站；电气主接线；变压器； 设备选型； 无功补偿 ? Abstract Ⅱ Abstract From the guide of engineering design assignment, we have to design primary power-system of 110kV substation and draw main electrical one-line diagram. There are two main transformer in the substation in which main electrical connection can be divided into three voltage grades: 110kV, 35kV with 10kV.It deposits sectionalized single bus bar scheme per grade. There is also a design for main electrical connection in this engineering, the calculation for short-circuit electric current, the selection of electrical device and calibration (including circuit breaker, isolator, current transformer, potential transformer ,bus bar etc.) and the design for distribution installation per. voltage grade, direct current system and lightning protection is also included Keywords:transformer substation; electrical main wiring; transformer; equipment type selection; reactive-load compensation 目录 Ⅲ 目 录  TOC \o 1-3 \h \z \u  HYPERLINK \l _Toc2699380 摘要 Ⅰ Abstact Ⅱ  HYPERLINK \l _Toc2699381 1 变电站电气主接线设计及主变压器的选择  PAGEREF _Toc2699381 \h 1  HYPERLINK \l _Toc2699382 1.1 主接线的设计原则和要求  PAGEREF _Toc2699382 \h 1  HYPERLINK \l _Toc2699383 1.1.1 主接线的设计原则 1  HYPERLINK \l _Toc2699384 1.1.2 主接线设计的基本要求 2  HYPERLINK \l _Toc2699385 1.2 主接线的设计 3  HYPERLINK \l _Toc2699386 1.2.1 设计步骤 3  HYPERLINK \l _Toc2699387 1.2.2 初步方案设计 3  HYPERLINK \l _Toc2699388 1.2.3 最优方案确定 4  HYPERLINK \l