最好用激光对中解析2.pptVIP

Section 4;Three stages in Shaft Alignment;4.1 Pre-alignment Procedures;A. 准备, off-site;B.现场的视觉检查On-site visual check;Machine temperature Gross soft foot Replace old shims Coupling assembly Mechanical looseness Run out Pipe strain Final soft foot Repeatability test;1. 机器温度;2. Correct gross soft foot;3. 替换旧垫片Replace old shims;4. Coupling assembly;6. Mechanical looseness;6. Check ”run out”;Set up the dial indicator The dial indicator plunger contacts the hub or shaft to be checked. It is affixed to any point in space: the machine base,a bearing housing, the adjacent coupling hub (if the couplin