超声波倒车雷达系统的设计论文40论文41.docVIP

PAGE   PAGE \* MERGEFORMAT 52 (此文档为word格式，下载后您可任意编辑修改！) 摘 要 采用超声波测距原理，驾驶者在倒车时，将汽车的挡位推到R挡，启动倒车雷达，在控制器的控制下，由装置于车尾保险扛上的探头发送超声波，遇到障碍物，产生回波信号，传感器接收到回波信号后经控制器进行数据处理，从而计算出车体与障碍物之间的距离，判断出障碍物的位置，再由LED显示器和蜂鸣器声发出警示信号，从而使驾驶者倒车时不至于撞上障碍物。整个过程，驾驶者无须回头便可知车后的情况，使停车和倒车更容易，更安全。 本文在查阅、分析国内外倒车雷达系统相关技术的基础上，结合最新研究成果，对基于超声波测距的倒车雷达预警系统的研制进行了深入探讨和研究。该系统分为测距模块、系统控制模块和显示报警模块，并分别对其进行方案分析，构建了倒车雷达预警系统的系统构架和设计方案；在硬件电路中，详细阐述了运用单片机技术实现的可视倒车雷达预警系统的测距实现原理，分析了以AT89S52单片机为主控单元的系统硬件设计，并通过系统仿真研究，验证了系统的可靠性和可行性。 关键字：超声波；倒车雷达；传感器；AT89S52单片机 ABSTRACT The ultrasonic distance principle, drivers in reverse, the gears to push the car back and start against R radar, under the control of the controller, the device to carry on the rear insurance send ultrasonic probe, obstacle, sensor, echo signal after receiving echo signal controller, which calculated data processing, the distance between the body and the obstacles and obstacles, then LED by a warning signal and noise, thus make the drivers reverse not mask obstacles. The whole process, without turning and car drivers that after, parking and reverse easier, more safety. Based on the analysis of domestic consulting, reverse radar system on the basis of relevant technology, combining the latest research results of the based onultrasonic ranging back-draft radar warning system is discussed and studied. This system is divided into rangefinder module, the system control module and display alarming module, and carries on the analysis, to construct the backing of the early-warning radar system architecture and design scheme, In the of visualization technology realization of location back-draft radar warning system, and analyzes the realization principle for the control unit of AT89S52 SCM system , and through the system simulation verified the feasibility and reliability of the system. Key words: ultrasonic sensors, radar, reversing AT89S52 SCM. 毕业设计（论文）原创性声明和使用授权说明 原创性声明 本人郑重承诺：所呈交的毕业设计（论文），是我个人在指导教师的指导下进行的研究工作及取得的成果。尽我所知，除文中特别加以标注和致谢的地方外，不包含其他人或组织已经发表或公布过的研究