空气采样使用说明书选编.ppt

系统 概 况 (System Overview) 激光腔 进气管 吸气泵 双段过滤器 显示单元 工作原理 Sampling pipes 采样管 Sampling points 采样孔 ASD Detector 探测器 4m 8m 8m 8m 8m 8m 8m 8m 4m 4m 4m Area Coverage 每个采样孔的平均保护面积20M2 标准采样时采样孔的布置方式Siting of Sampling Points Ceiling Sampling 吊顶下采样 Pipe on ceiling with Sampling Hole吊顶下安装的采样管 吊顶上空 Ceiling Void 吊顶天花 Ceiling Tiles 毛细管房间采样Capillary Room Sampling 毛细管Capillary Tube Ceiling Sampling 吊顶下隐蔽探测 Ceiling Sampling 吊顶下隐蔽探测 Capillary Sampling Points 毛细管采样头 方案1 Option 1 Roof Slab 楼板 Sample Hole采样孔 Sample Hole Sample Hole Sample Hole Sample Hole Sample Hole Sample Hole Sample Hole Trunk Adapter Roof Slab 方案2 Option 2 Inter-beam Sampling 梁间采样 假地板False Floor Slab楼板 Sample Holes Cable Ties 管道必须布置在上部 Pipe must be located at the top of the floor void Floor Void Sampling 地板下采样 Sample Hole 在管道侧面开孔 drilled in side of pipe T型接头 Tee 假地板 False Floor Slab 楼板 Floor Void Sampling 地板下采样 On/In-Cabinet sampling can provide the most optimum detection of a fire due to: Closest to the source, before dilution occurs Reduced time to detect, smoke is actively drawn from the source 柜上/内采样提供了最优的探测方案，因为： 在稀释之前，离火源最近 缩短探测时间，烟雾被主动地吸取 Dedicated detectors can provide the optimum protection 专用的探测器能够提供最优的保护 On/In-Cabinet Sampling 柜上/内采样 On-Cabinet Sampling 柜上采样 On-Cabinet Sampling 柜上采样 On-Cabinet Sampling 柜上采样 In-Cabinet Sampling 柜内采样 In-Cabinet Sampling 柜内采样 Return-Air HVAC Sampling 回风采样 Return-Air HVAC Sampling 回风采样 To avoid the low pressure point at the grille’s entrance, the sampling pipe should stand approximately 100 - 200mm (3.9 - 7.8”) from the return air grille. 为了避免回风格栅处可能出现的负压，采样管应该离格栅100-200毫米 It is recommended that the sampling holes are positioned to face the direction of the greatest airflow path 建议采样孔朝向最大的气流方向 Monitoring the exhaust of an AHU is not recommended as the filters can remove the presence of smoke 并不建议在AHU的送风口采样，因为空调的回风滤网已经将烟雾颗粒部分过滤 Return-Air HVAC Sampling 回风采样 The number of holes in the sampling pipework is determined by the aspirator’s capacity. 采样孔数量取决于气泵的