湖南省龙山至永顺二级公路初步毕业设计土木工程道路论文.docVIP

 PAGE \* MERGEFORMAT VIII (此文档为word格式，下载后您可任意编辑修改！) 湖南省龙山至永顺二级公路初步设计 摘 要 本设计是湖南省龙山至永顺二级公路初步设计，路段地处丘陵区，沿路地形起伏在400～600m之间，路线起止桩号从K4+000.000至K7+006，该公路的主要技术指标为路基宽度8.5m，双向双车道，无中央分隔带，设计车速60km of Hunan province Longshan to Yongshun two road sections in the preliminary design, the basin, basin surrounded by mountains surrounded by, its elevation in 400～600 meters between. The two stage technical indexes for of the speed60km is the two , first carried out the study on topographical map, in a familiar terrain map, access to the local topography and geology, of the two route alternatives, after comparison of technical indicators and the actual engineering situation, the final choice of relatively suitable scheme. In the course of graphic design, proceed with the longitudinal design, cross-sectional design, roadbed design, roadbed design is complete, start a pavement design, considering the actual situation of the project, finally decided to take the road design of cement concrete pavement. In the design of roadbed and road surface is completed, a retaining wall and drainage and protection design. The retaining wall is used in gravity retaining wall, drainage and protection design for the side ditch drainage ditches and drainage design. After conducting a culvert and the intersection of the plane of the preliminary design, the route need to construct two culverts, using pipe culvert form,Intersection using overlay corner . At the end of the project budget, project budgetary estimate, according to the actual situation, using aspect software over the budget, budget amount ofyuan. Keywords:Hunan,Longshan,Yongshun,two 目 录 TOC \o 1-3 \h \u  摘 要  PAGEREF _Toc17231 I ABSTRACT  PAGEREF _Toc2146 II 第1章 绪 论  PAGEREF _Toc16743 1 第2章 设计总说明  PAGEREF _Toc24080 2 2.1 地质地貌水文状况  PAGEREF _Toc20380 2 2.1.1 地形地貌  PAGEREF _Toc2127 2 2.1.2 气象水文  PAGEREF _Toc19039 2 2.1.3 地层岩性  PAGEREF _Toc17185 2 2.1.4 沿线材料供应  PAGEREF _Toc20918 2 2.2 工程概况  PAG