汽车防盗报警器的论文40论文41.docVIP

成都理工大学毕业设计（论文） PAGE   PAGE 33  PAGE \* MERGEFORMAT 1 (此文档为word格式，下载后您可任意编辑修改！) 汽车防盗报警器的设计 摘要 随着汽车数量增多，盗窃汽车的犯罪案件与日俱增，且车辆被盗的数量逐年上升，为了防止汽车被盗，给汽车装上防盗报警系统实有必要。对此提出了一种汽车防盗报警器的设计方案。 本论文介绍了一种制作容易、性价比高、实用性强的防盗报警器。在本设计中，用红外遥控器控制报警系统电源的通断，避免车主进入室内产生误报警；采用现在普遍应用于报警器中的热释电红外线传感器进行盗情信号的检测；用当今最流行的AT89C2051单片机控制，体积小、成本低。此报警器处于警戒状态下，发生盗窃时，传感器将检测到的信号送到单片机，经单片机分析处理产生声光报警，并且切断汽车点火线圈电源使汽车无法启动。 关键字:红外遥控、热释电红外传感器、AT89C2051单片机、声光报警 The Design Of Car Warning System Guarding Against Theft Abstract: As the quantity of personal automobile increases, cases of stealing cars rise day by day, causing the lost of automobile goes right toward the peak, to prevent the vehicles from being taken robbed, an anti-theft system including alarming module is absolutely necessary for every single automobile. Therefore a new scheme of anti-theft and warning system for vehicles is announced. In this thesis, an anti-theft alarm system with features of this design, inferred remote controller is in charge of control alarm system power source supply, to avoid the car owner triggers the warning by mistake. In sensing module, the pyroelectric inferred sensor is selected for detecting signals of stealing; And the most popular microcontroller AT89C2051 which the whole system is in guarding status, and stealing behavior detected, sensing module will send the detected signal to the microcontroller. After processing by the microcontroller, sound and light warning will be activated. And the vehicle will not be fired anyway because the automobile ignition coil power source will be cut off at the same time. Keyword: Inferred Remote Control, Pyroelectric Inferred Sensor, Microcontroller AT89C2051, Sound And Light Alarm 目 录  TOC \o 1-3 \h \z \u 第1章 前 言  PAGEREF _Toc170146341 \h 1 1.1 选题背景  PAGEREF _Toc170146342 \h 1 1.2全球汽车防盗报警器的现状  PAGEREF _Toc170146343 \h 1 1.3 本论文的主要工作  PAGEREF _Toc170146344 \h 2 第2章 汽车防盗报警器的总体方案设计  PAGEREF _Toc170146345 \h 3 2.1 方案设计要求  PAGEREF _Toc170146346 \h 3 2.2系