美国西屋公司AP1000-41.pdf

6. Engineered Safety Features AP1000 Design Control Document 6.1 Engineered Safety Features Materials This section provides a description of the materials used in the fabrication of engineered safety features components and of the provisions to avoid material interactions that could potentially impair the operation of the engineered safety features. A list of engineered safety features was given previously in Section 6.0. Reactor coolant system materials, including branch piping connected to the reactor coolant system, are described in subsection 5.2.3. 6.1.1 Metallic Materials Materials for use in engineered safety features are selected for their compatibility with the reactor coolant system and refueling water. The edition and addenda of the ASME Code applied in the design and manufacture of each component are the edition and addenda established by the requirements of the Design Certification. The use of editions and addenda issued subsequent to the Design Certification is permitted or required based on the provisions in the Design Certification. The baseline used for the evaluations done to support this safety analysis report and the Design Certification is the 1998 Edition, through the 2000 Addenda. When material is procured to later editions or addenda, the design of the component is reconciled to the new material properties in accordance with the rules of the ASME Code, provided that the later edition and addenda are authorized in 10 CFR 50.55a or in a specific authorization as provided in 50.55a(a)(3). 6.1.1.1 Specifications for Principal Pressure-Retaining Materials The pressure-retaining materials in engineered safety features system components comply with the corresponding material specification permitted by