机械毕业设计（论文）-飞锤支架工艺及车外圆及孔车床夹具设计（全套图纸）.doc

 PAGE II 常州机电职业技术学院 毕业设计（论文）说明书 作 者： 学 号： 系 部： 专 业： 题 目： 飞锤支架加工工艺及夹具设计 指导者： 评阅者： 年 月 毕业设计（论文）中文摘要 本设计是基于飞锤支架零件的加工工艺规程及一些工序的专用夹具设计，加工外圆及孔的车夹具设计。飞锤支架零件的主要加工表面是平面及孔系。一般来说，保证平面的加工精度要比保证孔系的加工精度容易。因此，本设计遵循先面后孔的原则。并将孔与平面的加工明确划分成粗加工和精加工阶段以保证孔系加工精度。基准选择以-中间拔叉的输入轴和输出轴的支承孔作为粗基准，以顶面与两个工艺孔作为精基准。主要加工工序安排是先以支承孔系定位加工出顶平面，再以顶平面与支承孔系定位加工出工艺孔。在后续工序中除个别工序外均用顶平面和工艺孔定位加工其他孔系与平面。支承孔系的加工采用的是坐标法镗孔。整个加工过程均选用机床。 关键词 飞锤支架，零件，加工工艺，专用夹具，设计 全套图纸，加153893706  PAGE   PAGE 17  PAGE 11 毕业设计（论文）外文摘要 Title： The flying hammer bracket parts fork processing technology and fixture design Abstract： This design is the special fixture for machining technology for the flying hammer bracket parts and process design based on car fixture design, machining and hole. The main processing surface flying hammer bracket parts is the plane and a series of hole. In general, ensure the machining accuracy of plane than to ensure the accuracy of the processing easily. Therefore, the design follows the surface after the first hole principle. And the hole and the plane processing clearly divided into roughing and finishing stages to ensure machining precision. Datum selection to the bearing hole in the middle fork of the input shaft and output shaft as a rough benchmark, the top surface and the two holes as a precision technology base. The main process of machining technology is first to support hole positioning processing the top plane, and then the top plane and the series of supporting hole location hole proces