RETA-01Quiet start.pdfVIP

ABB Oy RETA-01 Quick Start-up Guide pdf Drives Department Date Author Approved Revision Page ENO000 16.11.2006 Jere Syv?nne Mika J K?rn? 1.2 1/9 1 Quick start-up guide for RETA-01 Ethernet Adapter module 1.1 Overview This chapter describes the start-up procedure of the RETA-01 Ethernet Adapter module. Follow the safety instructions given in RETA-01 manual and the Hardware Manual of the drive. 1.2 Preliminary preparation ? Before installation, write down the MAC ID of the module (Printed on a sticker on the back of the module) ? Make sure you have the two screws for fastening the module 1.3 Configuring PC for point-to-point connection In this case point-to-point connection means that PC is directly connected to an IP-device such as RETA-01. ? Connect RETA-01 and the Ethernet card of the PC with a crossed Ethernet cable. ? Switch on the drive‘s power and wait that the PC recognizes the network connection. ? Select the ”Local Area Connection‘ menu corresponding the network card of the PC and bush the ”Properties‘ button. ? Select the ”Internet Protocol (TCP/IP)‘ from the selection list and click ”Properties‘ button. 1 ABB Oy RETA-01 Quick Start-up Guide pdf Drives Department Date Author Approved Revision Page ENO000 16.11.2006 Jere Syv?nne Mika J K?rn? 1.2 2/9 ? Select ”Use the following IP address:‘ bullet and configure the IP address you want to use. For instance: - IP address: 10.0.0.5 - Subnet Mask: 255.255.255.0 - Gateway address 10.0.0.1