Digital dental cast measurement of individual parameters.docVIP

 PAGE \* MERGEFORMAT 19 Digital dental cast measurement of individual parameters Of: Husong Yu, Cheng Xiaosheng, Dai Ning, Yuan natural, Yu Qing [Abstract] Objective: To evaluate three-dimensional figures based on the individual dental cast measurement parameters. Methods: First, the optical scanning system using three-dimensional model of the scanned dental cast three-dimensional digital model; and then follow the trend surface analysis method to determine the occlusal plane; then the occlusal plane of the crown-based cusp, dens automatic search algorithm to find the sharp point, the central dens, the use of relatively symmetrical plane established by the center line; the final measurement model parameters. Results: The crown of the global map obtained, the measured in which a crown width of 7.70 mm. select offset N is 0.8, get near the arch, in the far width respectively 37.69,38.14,49.66 mm; near, middle and far lengths 7.64,17.36,37.69 mm. Conclusion: The measurement method not only for orthodontic system, and statistical study of dental cast can be used as the measurement tools, has good application prospects. [Keywords:] digital dental wax; model measurement; computer aided design; Orthodontics Complete dental model can objectively record dentition, dental arch and palatal bone and the shape and position of basal bone and other important information. Dental cast measurements are used to study Orthodontics malocclusion factors, diagnosis design, develop treatment program an important step. Traditional manual measurement method [12] based on plaster model, the main use of some simple geometric measurement tools, including general or special ruler and caliper, manual measurement method was slow, difficult to measure the positioning error large. Nakashima [3] studied the 5-axis contact measurement device, the first directly measured by measuring the surface contact and record the measurement of the crown where the measuring points the first X,