Sample - Mastercam X5 Intro to Multiaxis Training Tutorial.pdfVIP

Intro to Multiaxis Training Tutorial To order more books: Call 1-800-529-5517 or Visit or Contact your Mastercam dealer 5 Mastercam X Intro to Multiaxis Training Tutorial Copyright: 1998 -2010 In-House Solutions Inc. All rights reserved Software: Mastercam X5 Author: Mariana Lendel ISBN: 978-1-926566-86-3 Revision Date: November 2, 2010 Notice In-House Solutions Inc. reserves the right to make improvements to this manual at any time and without notice. Disclaimer Of All Warranties And Liability In-House Solutions Inc. makes no warranties, either express or implied, with respect to this manual or with respect to the software described in this manual, its quality, performance, merchantability, or fitness for any particular purpose. In-House Solutions Inc. manual is sold or licensed as is. The entire risk as to its quality and performance is with the buyer. Should the manual prove defective following its purchase, the buyer (and not In-House Solutions Inc., its distributer, or its retailer) assumes the entire cost of all necessary servicing, repair, of correction and any incidental or consequential damages. In no event will In-House Solutions Inc. be liable for direct, indirect, or consequential damages resulting from any defect in the manual, even if In-House Solutions Inc. has been advised of the possibility of such damages. Some jurisdictions do not allow the exclusion or limitation of implied warranties or liability for incidental or consequential damages, so the above limitation or exclusion may not apply to you. Copyrights This manual is protected under International copyright laws. All rights are reserved. This document may not, in whole or part, be copied, photographed, reproduced, translated or reduced to any electronic medium or machine readable form without prior consent, in writing, from In-House Solutions Inc. Trademarks Mastercam is a registe