ECG-6511 ECG Machine Control Circuit Troubleshooting.doc

 PAGE \* MERGEFORMAT 7 ECG-6511 ECG Machine Control Circuit Troubleshooting [Abstract] ECG-6511 ECG machine is a lightweight and durable, simple, full-featured electrocardiograph. Widely used in various types of hospitals in China, a higher market share. Clinical use of the aircraft during the control circuit is sometimes one way or another failure occurs, this article describes several cases of common troubleshooting methods for the peer reference. Failure 1: Access to power, press the start button when the motor is not running away paper, recording paper does not take the paper, but the light brightness to normal. Analysis of maintenance: According to the failure to analyze the phenomena caused by the failure of the main reasons are: walking paper motor itself has a fault; walking paper motor drive circuit is bad; walking paper abnormal motor control circuit. First check the electrical connectors good contact, and then check the motor’s mechanical systems and electrical system, no anomalies, indicating motor itself is no problem. ECG recording will be placed on a state to measure the motor drive circuit transistor Q20l-Q203 DC working condition normal, indicating normal motor drive circuit, thereby to determine fault in the motor control circuit to go in the paper. Walking paper motor control circuit mainly by IC208A, IC208B, IC205B, IC205D, IC209, IC211A, IC211E, IC210 and other components formed. Open the power switch, the initialization circuit IC204 of 13 feet by 8 feet to the IC208A anyone to a positive pulse will trigger IC208A 9 feet set to zero, this time IC205B 8-pin also low, so that IC209 6 Output signal pin with 4-pin output signal IC205B, IC205D’s internal handling, and from 11 feet IC205D output control pulse. After power on, with the oscilloscope observation of the 14 non-IC210 input control pulse signal waveform, while the observation of 10 feet to join IC209 control pulse signal waveforms to normal, indi