东源名都9号楼临时用电方案答案.doc

 PAGE 29 施工现场临时用电设计 (一)施工条件 1、工程概况 本工程位于上海市浦东新区金桥镇源东住宅小区五街坊南端东临金京路，西临金高路，北临赵家沟，南临源华路，双桥路横穿小区。 本工程9#楼地下一层，地上16层，建筑高度为48.8m，地上建筑面积883.96㎡，地下一层建筑面积为526.08㎡。 2、施工现场用电量统计表 序号设备名称安装功率(kW)数量合计功率(kW)1砂轮切割机2.224.42圆盘锯3263台钻1.511.54增压水泵3135现场照明101106塔吊361367施工电梯401408砂浆搅拌机3139砂轮机1.511.510插入式振动器2.248.811平板振动器2.212.212弯曲机32613钢筋切断机3.52714钢筋对焊机2012015电焊机10220 (二)设计内容和步骤 1、现场勘探及初步设计 (1)本工程所在施工现场范围内无各种埋地管线。 (2)现场采用380V低压供电，设一配电总箱，内有计量设备，采用TN-S系统供电。 (3)根据施工现场用电设备布置情况，总线采用导线架空敷设，干线采用导线架空敷设，电机线采用电缆线空气明敷，布置位置及线路走向参见临时配电系统图及现场平面图，采用三级配电，两极防护。 (4)按照《JGJ46-2005》规定制定施工组织设计，接地电阻R≤4Ω。 2、确定用电负荷 (1)砂轮切割机组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 4.4 = 1.32kW (2)圆盘锯组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 6 = 1.8kW (3)台钻组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 1.5 = 00.45kW (4)增压水泵组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 3 = 00.9kW (5)现场照明组 Kx = 00.5，Cosφ = 00.9，tgφ = 0.48 Pjs = Kx×Pe = 00.5× 10 = 5kW (6)塔吊组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 36 = 10.8kW (7)施工电梯组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 40 = 12kW (8)砂浆搅拌机组 Kx = 00.7，Cosφ = 00.68，tgφ = 1.08 Pjs = Kx×Pe = 00.7× 3 = 2.1kW (9)砂轮机组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 1.5 = 00.45kW (10)插入式振动器组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 8.8 = 2.64kW (11)平板振动器组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 2.2 = 00.66kW (12)弯曲机组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 6 = 1.8kW (13)钢筋切断机组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 7 = 2.1kW (14)钢筋对焊机组 Kx = 00.3，Cosφ = 00.7，tgφ = 1.02 Pjs = Kx×Pe = 00.3× 20 = 6kW (15)电焊机组 Kx = 00.3，Cosφ = 00.45，tgφ = 1.98 Pjs = Kx×Pe = 00.3× 20 = 6kW (16)总的计算负荷计算，干线同期系数取 Kx = 1 总的有功功率 Pjs = Kx×ΣPjs = 1×(1.32+1.8+00.45+00.9+5+10.8+12+2.1+00.45+2.64+00.66+1.8+2.1+6+6) = 54.02kW 总的无功功率 Qjs = Kx×ΣQjs = 1×(1.35+1.84+00.46+00.92+2.42+11.02+12.24+2.26+00.46+2.69+