PPSPNATtraversal.pptVIP

* * * Thank you! * Thank you! * Thank you! * The necessity of NAT traversal depends on scenarios. #Some Scenarios need NAT traversal. In some Scenarios, the ratio of NATed peer is high in the swarm. Without NAT traversal, some peers cant download or take long time to download needed chunks. In some other scenarios, there is no NAT or the QoE is satisfied without NAT traversal solution. Any way, NAT traversal is necessary at least in some P2P streaming systems (e.g. UUSee). * The decision of supporting NAT traversal or not should be left to implementation. The choices of NAT traversal solution/method, NAT traversal service node and NAT traversal service discovery method should be left to implementation too. To make these choices, Implementation should consider things like the ratio of NATed peer, the ratio of each NAT type, implementation overhead and so on. * PPSP NAT traversal Lichun Li, Jun Wang, Wei Chen {li.lichun1, wang.jun17}@ chenweiyj@ draft-li-ppsp-nat-traversal-02 Changes since 01 Make change to PPSP-ICE solution Peer tries to contact remote peer’s host addr and reflexive addr first. If it fails, it turns to exchange ICE parameters and perform ICE process. Propose PPSP protocol extensions for NAT traversal Mainly based on gu-ppsp-tracker-protocol and gu-peer-protocol Mainly required by PPSP-ICE. RELOAD-ICE may also use some extensions. * NAT traversal solution overview ICE is the standard NAT traversal solution. ICE requires application to exchange ICE parameters. Two solutions in the draft: PPSP-ICE and RELOAD-ICE both use ICE but use PPSP and RELOAD separately to exchange ICE parameters (candidates and credentials for connectivity check). Candidate Candidate (from ICE RFC5245): A transport address that is a potential point of contact for receipt of media. Assigned by host itself, NAT device or relay node. NATed peers need NAT devices or NAT traversal service nodes to discover/assign candidates. * NAT traversal service nodes and candidates Dedi