Panelboards-SiemensIndustryInc.docVIP

SECTION [26 24 16] [16442] PANELBOARDS GENERAL SCOPE The requirements of the Contract, Division [26] [16] applies to work in this section. Panelboards as Specified and as shown on the contract drawings shall be furnished and installed by the Contractor. RELATED DOCUMENTS [Related Sections include the following: Section [26 28 16] [16410] - Enclosed Switches and Circuit Breakers Section [26 09 43] [16145] - Lighting Control Section [26 43 13] [16289] - Transient-Voltage Suppression For Low-Voltage Electrical Power Circuits Section [26 08 00] [16xxx] - Commissioning of Electrical Systems] SUBMITTALS The manufacturer shall provide the following information for review and evaluation by the Engineer: Shop Drawings showing circuit breaker or fusible switch layout, dimensions, voltage, phasing, continuous current capacity, and short circuit rating. Conduit entry location, cable termination sizes, mounting. Manufacturer shall provide final, as- built drawings, recording the actual circuiting of panels. Installation, Operation and Maintenance manuals shall be supplied. RELATED STANDARDS The panelboards and circuit protection devices shall be manufactured and tested according to the latest applicable standards of the following agencies: UL 50, Enclosures and Electrical Equipment UL 67, Panelboards UL 489, Molded Case Circuit Breakers and Circuit Breaker Enclosures UL 943, Ground Fault Circuit Interrupters NEMA PB1, Panelboards NEMA PB1.1, General Instructions for Proper Installation, Operation and Maintenance of Panelboards Rated 600 Volts or less. NEMA AB1, Molded Case Circuit Breakers and Molded Case Switches Federal Spec W-P 115, Rev. C, Panel, Power Distribution ANSI/NFPA 70, National Electrical Code ANSI/NEMA KS1, Enclosed and Miscellaneous Distribution Equipment Switches (600V) [Manufacturer Seismic Qualification: The low voltage panelboard(s) shall meet and be certified to seismic requirements specified in the [IBC 2009 International Building Code] [CBC 2010 Californi