下次买房一定要装榻榻米和高低床.doc

下次买房一定要装榻榻米和高低床，太喜欢了！?2013-12-25 15:42?阅读(1)?转载自﹢郑爽Q22OOOO一起看流星雨 赞(12583) 评论(1) 转载(1.29万) 分享(1.53万) 复制地址 编辑 上一篇?|?下一篇：10张内涵图：看懂... ? ? ? 本文出自一起来看流星雨郑爽QQ：220000，关注更多作品！? ? ? ? ? ? ? ? ? ? 极品上下铺设计 ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, constant support hangers, dampers, damper function, there should be factory calibrated test and performance test copies of the record. If necessary, review should be or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the we