单面接触和自动General接触的区别.docVIP

*CONTACT_AUTOMATIC_SINGLE_SURFACE 与 *CONTACT_AUTOMATIC_GENERAL的区别？ 和单面接触一样，*CONTACT_AUTOMATIC_GENERAL也是一个单面接触，接触完全 由从节点定义。两种接触类型均考虑壳单元和梁单元的厚度，即接触面由壳的中面和梁的中心线偏置得到的。为了接触目的，将梁单元的截面想象成圆形。在壳的边缘，接触面环绕成一个圆形，从而壳一边的接触面加入到了接触面的对边。 GENERAL接触一个重要的不同之处在于梁接触和壳边接触的方式是可操纵的。GENERAL接触检查梁单元整个长度上的穿透，不只是梁的节点。同样，GENERAL接触检查自由壳边上整个长度的穿透。也可通过增加选项，考虑内部壳单元的边。 另一个区别在于接触中从节点穿透触发释放的穿透值。对于GENERAL接触，该值是不受限制的，而单面接触是在穿透接近单元厚度一半的时释放穿透节点。 另一个不同，默认情况下，GENERAL接触通过三个最近的段检查节点接触（接触厚度 是3），而单面接触只检查两个段。三个段检查更有效，但是可能在接触角落处过硬。 默认的接触厚度对自动接触可能会重置*COTACT卡中的A. 基于段的罚公式SOFT=2，对单面接触是有效的，但不适用于GENERAL 接触。在单面接触中设置SOFT=2也改变了接触算法。 输出由单面接触产生的接触力到RCFORC文件中，必须定义*CONTACT_FORCE_TRANSDUCER_PENALTY。  What is the difference between *CONTACT_AUTOMATIC_SINGLE_SURFACE and *CONTACT_AUTOMATIC_GENERAL ?? ? Like*CONTACT_AUTOMATIC_SINGLE_SURFACE，*CONTACT_AUTOMATIC_GENERAL is a single surface contact, that is, the contact is defined wholly by the slave side. Both contact types consider shell thickness and beam thickness, that is, the contact surface is offset from the shell midplane and from the beam centerline. The beam cross section, for contact purposes only, is idealized as circular. At shell edges, the contact surface wraps around in a circular arc thus joining the contact surface on one side of the shell to the contact surface on the opposite side. $ n( o5 ]% s lOne important way in which an *CONTACT_AUTOMATIC_GENERAL contact differs from an *CONTACT_AUTOMATIC_SINGLE_SURFACE contact is the way in which beam contact and shell edge contact is handled. The *CONTACT_AUTOMATIC_GENERAL contact checks for penetration along the full length of beam elements, not just at the nodes of the beams. Similarly, *CONTACT_AUTOMATIC_GENERAL contact checks for penetration along the entire length of free (unshared) shell edges. By adding the option _INTERIOR to *CONTACT_AUTOMATIC_GENERAL in v. 960, edges of interior shells are also taken into account. * J; x. e7 j1 h4 WAnother distinction is in the value of penetration that triggers release of the p