安全生产责任制：管道工安全生产职责.docVIP

安全生产责任制：管道工安全生产职责 安全生产责任制：管道工安全生产职责提要：用车辆运输管材，要绑扎牢固，人力搬运，起落要一致，通过沟、坑、井，要搭好马道，不得负重跨越，用滚杠运输 安全生产责任制：管道工安全生产职责 一、目的和适用范围 1、目的 为明确本岗位的安全职责，特制订本规定。 2、适用范围 本责任适用于本公司管道工安全生产职责。 二、职责 1、用车辆运输管材，要绑扎牢固，人力搬运，起落要一致，通过沟、坑、井，要搭好马道，不得负重跨越，用滚杠运输，要防止压脚，并不准用手直接调整滚杠，管子滚动前方不得有人。 2、用克子切断铸铁管，应戴防护眼睛，克子顶部不得有卷边裂纹，用锯床、锯弓、切管器、砂轮切管机割管子，要垫平卡牢，用力不得过猛，临近切断时，用手或支架托住，砂轮切管机砂轮片应完好，操作时应站在侧面。 3、套丝要支平夹牢，工作台要平衡，两人以上操作，动作应协调，防止柄把打人，管子串动和对口，动作要协调，手不得放在管口和法兰接合处，手提式砂轮机应有防护罩，操作时站在砂轮片侧面，并戴绝缘手套或站在绝缘板上。 4、沟内施工，遇有土方松动、裂缝、渗水等，应及时加固壁支撑，禁止用固壁支撑代替上、下扶梯和吊装支架，人工往槽内下管，所用索具，地桩必须牢固，沟槽内不得有人。 5、用风枪、电锤或錾子打透眼时，板下、墙后不得有人靠近。管道吊装时，倒链应完好可靠、吊件下放禁止站人。 6、管道试压，应使用经检验合格的压力表，操作时，要分级缓慢升压，停泵稳压后方可进行检查，非操作人员不得在盲板、法兰、焊口、丝口处停留。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excell