对焊机安全操作规程（三）.docVIP

对焊机安全操作规程（三） 对焊机安全操作规程（三）提要：断路器的接触点、电极应定期光磨，二次电路全部连接螺栓应定期紧固。冷却水温度不得超过40℃；排水量应根据温度调节 对焊机安全操作规程（三） 1、对焊机应安置在室内，并应有可靠地接地或接零。当多台对焊机并列安装时，相互间距不得小于3m，应分别接在不同相位地电网上，导线的截面应符合要求。 2、焊接前，应检查并确认对焊机的压力机构灵活，夹具牢固，气压、液压系统无泄漏，一切正常后，方可施焊。 3、焊接前，应根据焊接钢筋截面，调整二次电压，不得焊接超过对焊机规定直径的钢筋。 4、断路器的接触点、电极应定期光磨，二次电路全部连接螺栓应定期紧固。冷却水温度不得超过40℃；排水量应根据温度调节。 5、焊接较长钢筋时，应设置拖轮，配合搬运钢筋的操作人员，在焊接时应防止火花烫伤。 6、闪光区应设置挡板，与焊接无关的人员不得入内。 7、冬季施焊时，室内温度不应低于8℃。作业后，应放尽机内冷却水。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The society, family moral education network, to achieve full member education, environment education, education service people, educating people. Traditional moral educati