全氧燃烧玻璃熔窑燃烧器安装高度的优化模拟.pdfVIP

33 3 武 汉 理 工 大 学 学 报 Vol.33 No. 3 2011 3 JOURNAL OF WUHAN UNIVERSITY OF TECHNOLOGY Mar. 2011 DOI: 10. 3963/ j. issn.2011.03.006 谢峻林, 金明芳, 梅书霞 ( , 430070) : 以全氧燃烧熔窑为研究对象,借助于 FLU NT 软件对玻璃熔窑火焰空间进行数值模拟对全氧燃烧条件下, 燃烧 安装在3 种不同高度时的熔窑火焰空间的温度场气流场和碱蒸汽对窑炉碹顶的侵蚀情况进行分析对比, 为燃烧 在全氧玻璃熔窑中的操作参数的确定提供依据, 对窑炉的设计和优化进行有效的指导研究表明, 燃烧 安装高度对 熔窑火焰空间温度分布有较大影响, 不合适的安装位置会导致对玻璃液面的传热效率下降碱蒸汽的挥发增强燃烧 安装在0.3 m 高度时, 气流有冲刷玻璃液面的倾向, 且气流平均速度较大; 燃烧 安装在 0. 5 m 高度时, 火焰气流翘起, 火焰空间底面附近的水蒸气的平均摩尔分数明显偏高,这些均易造成玻璃液面碱蒸气的挥发燃烧 安装在 0. 4 m 高 度时, 碱蒸汽的挥发率最小,但碹顶出现局部高温区, 火焰传热效率不高因此燃烧 的合理安装高度应该在 0. 3~ 0.4 m之间 : 玻璃熔窑; 数值模拟; 全氧燃烧; 火焰空间; 燃烧 : TQ 172 : A :2011 Numerical Simulation of the Effect Rule of the urners Installation Height on Combustion Space in Oxyfuel Glass Furnace X I E J unl in, J I N M i ng f ang , M E I S hux ia ( Key Laboratory of Silicate Materials Science and ngineering, Wuhan University of Technology, Wuhan 430070,China) Abstract: In this paper, numerical simulation with software FLU NT w as carried out in combustion space of an oxy fuel glass furnace. On the oxyfuel combustion conditions, when the burners installed in three different heights of the furnace,compare and analyze their temperature fields, flow fields and the erosion of the crow n by alkali volatilization in combustion space , which can provide basis for operating parameters of the burners and instruct the design and optimization effectively in oxyfuel glass furnace. Our research show s that the burners installation height has a great effect on temperature fields of the combustion space and inappropriate