木制饰面板施工方案（三）.docVIP

木制饰面板施工方案（三） 木制饰面板施工方案（三）提要：施工方案与技术措施①、弹线：根据设计图纸上的尺寸要求，先在墙上划出水平标高，弹出分格线 于房地产E网 木制饰面板施工方案（三） 1工艺流程 弹线→防潮层安装→木龙骨安装→基层板安装→饰面板安装。 2施工方案与技术措施 ①、弹线：根据设计图纸上的尺寸要求，先在墙上划出水平标高，弹出分格线。根据分格线在墙上加木橛或在砌墙时预埋木砖。木砖、木橛的位置应符合龙骨分档的尺寸，横竖间距一般为300mm，不大于400mm。 ②、防潮层安装：木质墙面必须在施工前进行防潮处理。防潮层的做法一般是在基层板或龙骨刷二道水柏油。 ③、木龙骨安装：本工程所有木龙骨的含水率均控制在12％以内，木龙骨应进行防火处理，可用防火涂料将木楞内外和两侧涂刷二遍，晾干后再拼装。根据设计要求，制成木龙骨架，整片或分片拼装。全墙面饰面的应根据房间四角和上下龙骨先找平、找直，按面板分块大小由上到下做好木标筋，然在空档内根据设计要求钉横竖龙骨。龙骨一般采用30mm×40mm截面龙骨，龙骨网格一般为300mm×300mm。基层龙骨固定：安装木龙骨前应先检查基层墙面的平整度、垂直度是否符合质量要求，如有误差，可在实体墙与木龙骨架间垫衬方木来调整平整度、垂直度。同时要检查骨架与实体墙是否有间隙，如有间隙也应用木块垫实。没有木砖的墙面可用电钻打孔钉木橛，孔深应在40-60nun之间。木龙骨的垫块应与木龙骨用钉牢。龙骨必须与每一块木砖钉牢，在每块木砖上用两枚钉子上下斜角错开与龙骨固定。 ④、封钉胶合板，可用纹钉固定或胶固定，把木夹板固定在木龙骨上。封钉前，就调整好生块板的拼缝，要求布钉均匀，钉距100-150mm左右。 ⑤、饰面板安装：用于木质墙面的饰面板，使用前应进行挑选，将色泽相同或相近．木纹一致饰面板拼装在一起。木纹对接要自然、协调，毛边不整齐的板材应将四边修正刨平，微薄板应先做基层板，然后再粘贴，清水油漆饰面板应避免顶头密拼连接。饰面板在背面涂刷二遍防火漆。 于房地产E网 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assi